The U-joints can be replaced separately - you do NOT need to replace the entire shaft.
Thecvman on EBay sells the replacement u-joints for only $34. The original ones are made to be staked into the yoke ends, so you'll need to grind down the staked part (the little dimples that hold the caps in place) with a Drummel or abrasive roll cartridge. The replacement u-joint use "c" clips on the inside of the yoke so you won't need to re-stake them in place.
drive universal jount
You have to replace the whole drive shaft.
with a u-joint press or c-clamp, there is a procedure, consult a repair manual, probably at your local library.
You probably mean U - joint (universal joint)! Located at each end of drive shaft or axle and possibly in the middle of drive shaft.
You most likely have a bad universal joint. This universal joint is located in the drive line of the vehicle and needs replaced as soon as possible.
How much does it cost to replace a cv joint on 4 wheel drive
You don't the crv uses cv joints on their axles.Another View: There ARE universal joints on the All-Wheel-Drive models of the CR-V. They are what allow the power to be transferred from the transmission to to the rear differential to transfer power to the rear wheels
Much better to replace the whole axle, look at www.happywrenching.com for a guide on how to replace an axle in a Honda Odyssey
You probably mean U - joint (universal joint)! Located at each end of drive shaft or axle and possibly in the middle of drive shaft.
how do you replace the drivers side drive shaft and cv joint?
The universal joint is used to transfer drive (power) from one shaft to another when they are inclined (non collinear) to each other.
== == US built trucks use a Neapco 1-0430 to replace factory staked-in joints on 4 cylinder models. Japan built 4 cylinders and V6 models use different ones, usually a Precision 369. == == you can't replace it you have go to a drive shaft company to replace it.. it's press on about $100 for both joint and balance drive.