Yes
A special 18 mm spark plug wrench. Use the Honda spark plug Wrench which comes with the standard tool kit below the seat. Use this and you will get all the plugs out easily.This 18 mm wrench is thinner and longer than a regular spark plug wrench. If the original wrench is no longer in your bike, you have to buy a new one.
to change the spark plugs first take off the plastic cover on top of the motor, the spark plugs are on the center of motor you see two coils on top of the two center spark plugs and two spark plugs wires going to the out side spark plugs you pull the wires off and you need a long socket wrench or a spark plug socket with extension bar to take it off, also you need to pull the coils to replace the center spark plugs they are under the coils. NOTE. this is for a four cylinder engine. excuse my English B. Cerda.
The coils are bolted to the side of the engine, The spark plugs are under the coils, NO PLUG WIRES. unbolt the coils and use A spark plug socket.
to change the spark plugs first take off the plastic cover on top of the motor, the spark plugs are on the center of motor you see two coils on top of the two center spark plugs and two spark plugs wires going to the out side spark plugs you pull the wires off and you need a long socket wrench or a spark plug socket with extension bar to take it off, also you need to pull the coils to replace the center spark plugs they are under the coils. NOTE. this is for a four cylinder engine. excuse my English B. Cerda.
Remove the plastic covers of the air intake systems. There are two black rectangular covers on each side of the engine bay. Remove the bolts, the coils and spark plugs will be exposed. There are four (4) on each side, when you look down from the hood, from the front end of the car. Note: Special tools are needed: Female torx wrench to open the cover, Allan wrench to open the spark plug pack, plus the regular spark plugs tools you used. weijen_hsu@yahoo.com
99.999% or vehicles ever made are negative ground. If your wrench slips while taking off the negative cable and hits the chassis it will not cause a spark. If you are removing the positive first and you slip, it will cuase a major spark.99.999% or vehicles ever made are negative ground. If your wrench slips while taking off the negative cable and hits the chassis it will not cause a spark. If you are removing the positive first and you slip, it will cuase a major spark.
You can change your spark plugs by locating the old ones and removing them. You can insert the new ones by locating the spark plug hole and then threading them in. It is easier if you use a socket wrench to install them.
YOU CAN REMOVE THE SPARK PLUGS WITHOUT REMOVING ANYTHING EXCEPT THE SPARK PLUG WIRES IN THE REAR USE A SWIVAL AND EXTENSION AND WORK ON BOTH SIDE AND THE MIDDLE OF THE PLETNIUM THE FRONT SPARK PLUGS NEED JUST TO REMOVE THE THREE COILS
follow your spark plug wires under the motor to the ignition module where the coils are mounted and the wires are attached to them. use a wrench and a screw driver to take off the module and the coils. do not lose the plug firing order.
To replace spark plugs, you can use a socket wrench, but a socket made for removing and replacing spark plugs is needed. This socket is relatively inexpensive and can be found at most auto parts stores.
Two coils two spark plugs are under the coils and the other two are next to the coils
A 2000 Concorde does not have plug wires. There are individual coils on each spark plug.A 2000 Concorde does not have plug wires. There are individual coils on each spark plug.