First understand rolmex is not rated by voltage, there is no 110 V only rolmex. You might be referring to rolmex that has only two conductors (black & white) and a bare ground wire. Most 220 V "appliances" require two hot wires, a neutral and a ground. Check the hook up on your appliance. If it does require a neutral, then you need three conductor with ground wire. The important thing here is that you use the right size or gauge wire. The wire must be able to carry the appliances required amperage.
Again, check the wiring hook up on your appliance and then check the amperage required. Then go to the hardware store, etc. and buy the correct size (gauge), and number of conductors in the wire. Tell the clerk in the electrical dept. exactly what your supplying power to and they'll likely get you the right wire.
Yes, the 265 volts is just the maximum the appliance can handle. You can use it on a 240 volt circuit.
Yes, a 220 volt appliance can be installed in your home.
Yes
The safe operating range of voltages for the appliance should be marked on the back, near where the cable enters the device. Using an applicance at an excessive voltage could cause overheating which might destroy the appliance and could cause a fire.
Probably not, but I have yet to see a 150 volt appliance as this is a non-standard voltage. If you are referring to a 115 volt appliance then the answer is yes you can as 110/115/120 volts tend to be used interchangeably in practice and are close enough together to not affect operation of the appliance.
Yes, the 265 volts is just the maximum the appliance can handle. You can use it on a 240 volt circuit.
Yes. Circuits in a home are 120 volts but people tend to call them 110 volt circuits. The 120 volts you read on the appliance is the maximum voltage the appliance can handle. The actual voltage you will read at any outlet will range from 110 to 120 volts.
You will have trouble plugging a 220 volt appliance into a 110 volt outlet because both have different polarities for the plug and receptacle that make it impossible for that action to happen.Altering the plug isn't too good of an idea, as the voltage demand of the appliance would be too heavy for the wiring.
No, the applied 110 volt is too high for a 3 volt appliance. The appliance would burn out right away.
Yes, a 220 volt appliance can be installed in your home.
Yes
The voltage cannot just be increased in a circuit because there is a risk of damage, blown circuit breakers and/or fire. However an appliance desgined to run on 220 v will use 6/11ths of the current used by an identical appliance designed for 120 v.
NO
NEC 220.52(A) & (B) state that an additional load of not less than 1500 volt-amperes shall be included for each two-wire small appliance circuit and each laundry circuit.
That appliance might last longer if you use an eight volt adapter rather than a nine volt adapter.
The safe operating range of voltages for the appliance should be marked on the back, near where the cable enters the device. Using an applicance at an excessive voltage could cause overheating which might destroy the appliance and could cause a fire.
A volt can not be connected to a circuit.