take out the ash tray. gently pull up the plastic cover around the gear shifter pulling from the bottom area where the ash tray was. put the gear shifter in neutral to take the cover off (you will need to unplug the cigarette lighters to take off completely). next take the black panel off with the PRND2 by gently releasing the 2 clips on each side front and back, you do not need to take this off completely. you will see the light on the left side. gently turn the light casing 90 degrees to pull it out. replace the bulb, reverse procedures
Begin by removing the 2002 Jeep Liberty shift console retaining bolts. Lift the shift console up and the light bulb will be visible. Take hold of the light bulb, push in and turn at the same time to remove it. Reverse the process to install your new shift console light bulb.
If the light for the gear shift on the console does not work on a 2002 Toyota Camry, it is probably a burned out bulb. The console will need to come off to access the bulb to change it. This part is held onto the console area by screws.
Just remove the console and you can get to it.
I have a Haynes manual and it shows that you pry off the molding around the shifter. At the 4 corners there are screws that allow you to remove the plastic shift console. Inside on the drivers side is the light bulb. Mine is also out. I have been trying to find out the bulb before I disassembled the shift console. Do you know the bulb spec? Pat Dailey patdailey@comcast.net
how to replace the light bulb on the gear shift on 2004 tracker
If you are referring to the shift position indicator located next to the shift lever - YES, it is supposed to be illuminated when the headlights (not the DRL's) are activated.
how do you change the light on the gear shift of a 2003 Lincoln navigator
If you have an automatic transmission. Then you do not have a shift indicator light.
un push the button on the shift console. done.
You have to remove the console cover. This starts with two screws in the console storage tray.
how to change light bulb light on the gear shift for a toyota matrix 2007
Unscrew the shift knob. squeeze the plastic underneath - there are 4 tabs holding it in; it will lift out. There are a few more sections that will come out similarly - your entire console will come out that way. There is a great video on how to do this here. http://www.youtube.com/watch?v=9pggHl_sCOo