Want this question answered?
On the Daewoo Leganza it is located behind the AC compressor.
The camshaft position sensor is located in the engine compartment of the 2002 Daewoo Leganza. It is at the end of the camshaft housing.
In the air tube just after air filter.
Hope this will help it happend to me. It was my cam sensor and the dealer fixed it for free.
P1780 Push - Pull Sensor Mal, could you please explain what the push - pull sensor is please?
Here is a link for a parts place. http://www.partsamerica.com/ProductList.aspx?parttype=985&ptset=A&searchfor=Cam+Position+Sensor
cmp snsr will not prevent the car from starting,ckp snsr would.
Located behind the A/C Compressor. You will need to remove the P/S Pump, A/C Compressor then the bracket that holds them both.
Perhaps throttle plate is stuck? I have a Could 1997 Daewoo Leganza, every now and then the car goes into high revs each time I start it up, what I do is unhook the battery over night and this works, seems to reset some sort of sensor.
when you open your hood and you look on the valve cover you see on your left side of top of your cover a cable sticking out from a black piece that is the positioning sensor that cranksup the car.
presentation of pancreatitis
The crankshaft position sensor is located behind the cam gears. you have to remove the timing belt to get to it. If your not having any problems don't fool with it. This is actually the camshaft sensor, the crankshaft sensor is down near the crankshaft and is the wire that runs up over the timing belt inside cover. It is very hard to reach and not many diagrams on it.