0
To change the a wheel assembly on a car:
1. Loosen the lug nuts.
2. Raise the car as required and put on a stand.
3. Finish taking off the lug nuts.
4. Remove the wheel and put the replacement wheel in place.
5. Put the lug nuts back on, remove the stand and lower the car.
6. Tighten the lug nuts.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Changing brake rotors on 2000 Chevy s10?
2 wheel or 4 wheel drive, front or rear rotors, it makes a big difference.
Changing rear wheel bearings in a 1999 Chevy Tracker?
you dont,you take it to a shop and pay them 500 dollars to fix it
How do you remove the front axle shaft in a 2001 dodge ram?
you have too take off the wheel then the brakes, then you have to remove the 3 bolts on the back of the wheel assembly and lightly take a mallet and tap the wheel assembely out. and it all just pulls out after that.
Does changing a front wheel bearing on a 2004 Chevy Silverado 1500 require a special tool?
yes,it requires two special sockets for the inner and outer wheel nuts inside the hub
Changing wheel bearings 2001 Chevy Venture?
Front wheel drive vehicles are a little more involved than changing them on a rear wheel vehicle. You basically have to take off the whole steering knuckle. You also need to press out the bearing from the hub and remove the race from the spindle with an air tool cutting wheel. The hub is held on by several bolts on the back near where the axle goes into the hub.
Do you do a wheel alignment before or after changing rotors?
after changing rotors
Is a 86 Chevy caprice front wheel drive?
No , a 1986 Chevy Caprice is REAR wheel drive
How do you remove steering wheel Chevy lumina 2000?
How to remove steering wheel on Chevy lumina 2000
How do you remove the steering wheel on a 2001 Chevy Tahoe?
How to remove steering wheel on a 2001 chevy tohoe
Why does your 1991 Chevy Cavalier make a buzzing sound from the front left when driving straight or turning left but not when turning right?
This buzzing indicates that the wheel bearings need to be replaced on your front left wheel. This can be fixed by changing the bearings themselves or replacing the entire wheel hub.
Changing brakes on a Chevy uplander?
Remove the wheel. Next, remove the springs and the retaining clips. The brake pads will come off. Reverse the process to install the new brakes.
How do you remove rear wheel bearings on a Chevy Cavalier?
Remove the tire and wheel from your Chevy Cavalier. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
