0
Could a bad turn signal relay switch cause only the right rear signal to not work All other turn signals work.?
Wiki User
∙ 14y ago
As as rule... No.
Usually automobile turn-signal circuits separate left and right sides (not rear and front).
Assuming the bulb is OK and the correct one (double filament?) your most likely culprit is going to be the socket on the one that does not work or it's wiring connection.
Depending on the design, the hazard-switch could be at issue too as these devices switch the wiring loom connections around when the engage or disengage.
Good luck.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What could cause my 1989 Mercury Topaz's brake lights to not work when all the bulbs are good?
A defective brake light switch could cause the problem. Also a defective turn signal switch could also. The brake lights work through the turn signals. It cancels the brake light so that the turn signal can work.
What would cause the turn signals to go off and on everytime you hit a bump?
The turn signal switch is probably a bit loose, so the bumps are jostling it enough for it to switch on.
Can the turn signal switch cause the horn to stay on?
No. The horn and the turn signals are on completely different fuses and wiring. I don't know why you thought that the horn could be made to stay on by the turn signal, but that's your answer. ========== The turn signal switch and it's plastic housing could pinch the horn wire against the steering column and cause the horn to sound. You would probably hear a change when you wiggle or click the turn signal switch. This can happen because many horn relays are activated by grounding the wire inside the steering column, so if the insulation is damaged it can easily be made to sound.
What can cause the turn signals not to work on a 1993 Chrysler Lebaron when the fuses and bulbs and flashers work and the turn signal switch in the steering column has been replaced?
Check the connector pins on the housing that contains the signal switch and the headlight switches that connect to the signal light switch these pens are famous for coming loose fron the circuit board thy are soldered to. had to replace my switch housing.
Why would the turn signals and hazard flashers on a 2001 Lumina all fail at the same time?
Because the hazard/turn signal relay has failed. A defective/intermittent turn signal switch can also cause this symptom.
Turn signals not working on a 92 mercury marque?
A burnt out signal bulb, a faulty blinker relay, a faulty blinker switch, a loose connection or a broken wire are all things that can cause the turn signals not to operate properly.
What could cause the brake lights to stop working on a 1992 Camaro RS if the bulbs and fuse check out ok?
If the turn signal is working it's either the brake light switch or the turn signal switch.
What will cause your rear signal lights to not work when the front headlamps are working on your Chevy venture?
it is most likely a fuse or at worst the turn signals and stop lights work through the turnsignal switch
Would a 1998 Volvo v70 hazard flasher switch cause the turn signals to stay illuminated?
Yes. The relay that controls the turn signals is built in the switch.
What could cause the turn signals on a 2001 Explorer Sport to not functions besides fuses and bulbs?
Try checking the turn signal flasher. Not to be confused with the hazard flasher.
What would cause the turn signal clicker in a 1996 Honda Accord EX to click constantly even when the car is off except when signals are engaged at which time it clicks normally?
What you describe could be caused by the Hazard Light switch being turned on. When you observe this symptom, get out and check to see if the parking lights are flashing. If they are, then find the Hazard Light switch and turn it off.
What would cause the turn signals not to work on a manual 1994 Chevy S10 Ext Cab after you replace the turn signal switch at the steering column and both relays under dash?
Perhaps it is the wiring or a fuse that has broken.
