0
Could someone tell you how to fix the code c1095 in your 1997 grand marquise?
Wiki User
∙ 18y ago
C1095 indicates a hydraulic pump motor circuit failure. First check to see that the 2-pin connector from the brake pressure control module is fully seated and has good terminal contact and no corrosion. If no, connect. If yes, check the pump motor. If the pump motor does not run, disconnect the 2-pin connector on the inside of brake control module, ground the brown wire and apply 12V to the red wire. Then again check to see if the pump motor runs. If it does not you will need to replace the anti-lock pump and motor assembly.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
Could you Show me a diagram of firing the order for a 1998 mercury grand marquise?
Here is a diagram.
1996 Mercury Grand Marquise Where is the interior lighting switch on the door?
I have a 1996 Mercury Grand Marquise. Where is the interior lighting switch on the door.
How do you get to the water pump on a grand marquise?
what year
What color is the power wire on a grand marquise radio?
red
What grounds the ac blower motor on a 2000 Mercury Grand Marquise?
EATC
Do a 92 grand marquise have rear breaks?
Hopefully , yes ( if everything is working properly )
How do you calibrate digital gas gauge on 01 mercury grand marquise?
There is no adjustment or "calibration" for this.
Something with wheels that starts with a g?
go-cart Gremlin (a brand of car) Grand Marquise golf cart Grand Cherokee jeep
Why does your 1992 Mercury grand marquise smell like gas?
Fuel leak? Defective carbon canister?
Where is the heater hose located on a 1993 mercury grand marquise?
Should be against the firewall towards the passenger side
Is A 1984 Grand Marquise Driven In Overdrive Or D?
Leave it in o/d . The trans. will work just fine.
Why does my trunk stay wet?
Bad gasket, latch not fully holding trunk closed.
