8.5s were available in certain later model S10s, starting in '95. They are essentially a bolt in, however the existing driveshaft may need to be shortened slightly, as the pinion on the 8.5 is slightly longer as measured from the centerline of the axle assembly.
It is not a direct bolt in, But if you know what you are doing you can modify it and make it fit.
That is a 1965 Chevrolet Chevelle 12 bolt rear differential.
All you need to do is count the bolts that hold the rear end plate on the housing.
NO. That is a lite duty rear end.
You can adjust the rear brakes with the rear brake adjustment bolt. The rear brakes should adjust automatically every time you back up and use the brake.
It is what the rear wheels bolt to.It is what the rear wheels bolt to.
GM8.5 inch 30 spline 10 bolt 3.73 gear ratio , 41x11
I am changing rear disc brake pads on a 2004 Chevrolet Malibu lt can I get step by step instructions to make it easier for me.
1st make sure that rear service brakes are adjusted properlyThere should be an adjusting bolt either under the vehicle at the junction of the 3 cables or at the parking brake itself
1974 c20 chevrolet rear axel. 4.56 gearing. 8 bolt wheel. {corporate 14} 8.5 gear. ill bet a pepsi on that one. thank you GW
Make sure it is unloaded. Then lift the bolt handle and slide it to the rear. There is a small lever on the rear left of the gun, pull this outward from the front. With it pulled out finish sliding the bolt out of the action.
The 2005 Chevrolet Impala has 58.9 in. of rear shoulder room.