Want this question answered?
Dist. Points gap is .016" (0.4mm)
you un do the two bolts after lifting the dist cap off and the dist will come rite off from the head,then replace it be sure to set the new dist gear in the same pos as the old one
driver frt cyl and dist points to pass frt
There shouldn't be any difference in the wiring. The hot wire from the switch goes to the + side of the coil, and the pigtail wire from the points goes to the - side of the coil.
If engine turns over but dist. doesn't turn you either have a broken dist. drive hex shaft , broken dist. shaft or holding pin for dist. drive gear on bottom of dist. has sheared off.Pull off dist. cap and try to turn rotor on end of shaft. It should not turn freely.If it does then pull dist. out of motor by removing hold down clamp. Mark rotor position with felt pen mark on dist. housing before removing dist. for proper replacement position.
V8 Dist at front-1-2-7-8-4-5-6-3 V8 Dist at rear-1-8-4-3-6-5-7-2 V6 1-6-5-4-3-2
The address of the Historical Society Of The Us Dist Court For Eastern Dist Of is: C/O Mcguirewoods L, Richmond, VA 23219
the firing order 1-8-4-3-6-5-7-2. okay this is the way i set mines. on the dist. the number 1 plug terminal (should be facing the cyl. bore number one) then from there go clockwise in the firing order. another way is to look at the dist rotor when the number 1 cyl. is in top dead center(be careful there are two top dead centers for ever dist. rotation). when you have the right top dead center then go by the dist. rotor to which every dist. plug terminal the dist. rotor points to, that would be number one plug wire then go clockwise in firing order.
if you remove the dist cap there is a small peice with 4 wires on it its held on with two screws on the outside of the dist if you remove the dist cap there is a small peice with 4 wires on it its held on with two screws on the outside of the dist
Done in open Convention at the City of Guthrie, in the Territory of Oklahoma, on this, the sixteenth day of July, in the year of our Lord one thousand nine hundred and seven, and the Independence of the United States of America one hundred and thirty-first. ATTEST: JOHN McLAIN YOUNG, Secretary. WM. H. MURRAY, President of the Con- stitutional Convention of the proposed State of Oklahomaand Delegate from District No. 104. PETE HANRATY, Vice President ATTEST: CHAS. H. FILSON, Secretary of Oklahoma. ALBERT H. ELLIS, Second Vice President and Delegate 14" District. Philip B. Hopkins, District No. 75. William N. Littlejohn, Dist. 78. C. N. Haskell, District 76. James R. Copeland, Dist. 62. C. S. Leeper, 96. C. V. Rogers, Dist. 64. T. O. James, Dist. No. 1. B. E. Bryant, Dist. 47. C. H. Pittman. J. S. Latimer, 99. J. H. N. Cobb. Jno. B. Harrison, 45. C. N. Board, 73. Joel M. Sandlin, Dist. 22. W. S. Dearing, Dist. 44. L. J. Akders, Dist. 102. David S. Rose, Dist. 15. John L. Mitch, Dist. 29. Geo. A. Henshaw, Dist. 107. W. A. Ledbetter, District 103. W. F. Hendricks, Dist. 10. Christopher C. Mathis, Dist. 100. James H. Chambers, Dist. 105. Edwin T. Sorrells, Dist. 92. William J. Caudill, Dist. 50. Carlton Weaver, Dist. 87. Cham Jones, Dist. 101. Henry S. Johnston, Dist. 17. John M. Carr, Dist. #54. J. E. Sater, Dist. 20. I. B. Littleton, Dist. No. 32. Milas Lasater, District 94. J. B. Tosh, Dist. 52. Samuel W. Hayes, District 85. J. K. Hill, Dist. 63. James I. Wood, Dist. 89. J. J. Savage, Dist. 48. David Hogg, Dist. 43. J. S. Buchanan, Dist. 34. Flowers Nelson, Dist. 68. J. C. Graham, Dist. 106. Delphas G. Harned, Dist. 9. J. A. Alderson, Dist. 12. J. Howard Langley, Dist. 65. Boone Williams, Dist. 97. G. W. Wood, Dist. #8. W. L. Helton, Dist. 24. S. W. Ramsey, Dist. 30. Edward R. Williams, Dist. 3. R. L. Williams, District No. 108. J. F. King, Dist. No. 16. Henry L. Cloud, Dist. No. 23. J. W. Swarts, Dist. 61. E. F. Messenger, Dist. #82. W. E. Banks, Dist. No. 51. John J. Carney, Dist. 36. R. J. Allen, Dist. 93. Gabe E. Parker, Dist. 109. Charles M. McClain, Dist. No. 86. W. C. Hughes, District 28. Fred C. Tracy, Dist. No. 2. H. O. Tener, District 42. G. M. Berry, Dist. No. 18. Joseph J. Curl, 57. William C. Liedke, Dist. 83. O. H. P. Brewer, 77. J. A. Baker, Dist. 81. George Norton Bilby, 6. T. C. Wyatt, Dist. 33. C. H. Bower, Dist. 41. Charles L. Moore, District No. 13. J. K. Norton, Dist. 35. A. L. Hausam, Dist. 70. W.T.S. Hunt, Dist. 27 J. J. Quarles, District #56. A. S. Wyly, Dist. 72. Ben. F. Harrison, District 88. William H. Edley, Dist. 53. E. G. Newell, Dist. 19. Neal B. Gardner, #91. Hamner G. Turner, Dist. No. 80. James A. Harris, 71. Thad D. Rice, Dist. 38. Benjamin Floyd Lee, 110. A. G. Cochran, Dist. 98. Territory of Oklahoma, Logan County: I, Wm. H. Murray, President of the Constitutional Convention of the proposed State of Oklahoma, do hereby certify that the within and foregoing is the original parchment enrollment of the Constitution and the several articles thereof adopted by the Constitutional Convention of the proposed State of Oklahoma, to be submitted to the people of the proposed State of Oklahoma for ratification, and that all the interlineations therein contained and all the erasures and words stricken out, were made and done before the same was signed by the President, the Vice-Presidents, and the members of said Convention. Witness my hand this the sixteenth day of July, A. D., Nineteen Hundred and Seven. Wm. H. MURRAY, President of the Constitutional Convention of the proposed State of Oklahoma ATTEST: JOHN McLAIN YOUNG, Secretary.
It's in the dist. The dist. itself is the cam sensor.
If the whole dist. turns then the dist. hold down clamp is loose. If the rotor button turns all the way around then the roll pin in the bottom of the dist. drive gear is broken. Remove the dist. and inspect the cam gear and dist. gear closely. A BAD OR LOCKED UP OIL PUMP IS THE REASON FOR THIS.