The upper ball joints come with a new control arm , as far as I know you can't just
change the balljoint ( if that's what you are asking ? )
I believe you can change just the ball joint on the lower control arms , the upper ball joints come with a new control arm
My Haynes repair manual ( 1991 thru 2001 Ford Explorer ) shows on 1995 and newer that the balljoints on upper and lower control arms are not removable or serviceable . If a balljoint is damaged or worn , replace the control arm . ( my Chilton repair manual also shows the same information )
# 17 is a 20 amp fuse for the cigarette lighter and Data Link Connector in a 2001 Ford Explorer Sport
You have to replace the lower control did assembly .
Look in removable housing at the engine end of the upper radiator hose
On a 2001 Ford Explorer the airbag control module is located behind the passenger side kick panel (located to the right of the passengers right foot if seated in the vehicle).
Weekend Explorer - 2001 was released on: USA: May 2001
my cruise control light will blink on an off and the care will move.when it is not blinking the truck will not move, why is that
The 2001 Ford Explorer has a V6 engine.
The 2001 Ford Explorer has 12 valves.
I have a 2001 Ford Explorer sport trac and the module is located behind the front passengers side panel. I would have to believe that the 2002 Explorer would be the same.
To replace ball joints on a 2004 2WD Ranger, lift the upper control arm of the spindle assembly and remove the nut holding the lower ball joint in place. Then lower the lower control arm to relieve the ball joints. Replace with new.Ê