Want this question answered?
Add Engine Flush to the motor oil at running temperature before changing the oil. After adding the product, allow the engine to idle for approx. 10 minutes. Then change the oil and the filter. Engine Flush is compatible with all commercially available motor oils. We recommend cleaning the engine interior with Engine Flush before every oil change.
The Crank Case is dirty. Use a good Crank Case cleaner to solve problem like Motor Medic Motor Flush. Warm engine 5 minutes and let clean out for 5 to 7 minutes. Then drain and use fresh oil.
Yes, they are the same. Some people call an automobile engine a motor and some people call it an engine. It is actually an engine and a motor is a electrical device. But motor oil and engine oil for all practical purposes are the same thing.
With the engine off for at least 15 minutes, remove the dipstick and look to see if the oil is at the full mark.
No you do not, but you will have to take the motor mounts loose and raise the engine up a few inches.
yes. You usually need a few minutes to let the oil circulate in the engine. If you dont , the first few minutes of driving might wear the moving parts that the oil is meant to protect.
I would not advise it. SEA30 motor oil is a single viscosity motor oil. This means that the thickness of the oil never changes. Multiviscosity motor oils acually thicken as the engine gets hotter. This allows the oil to be thinner at start up therefore it is able to lubricate the engine faster during the first few seconds of the engine running. This is when most engine damage occurs. It is best to stick with the recommended oil. I am a member of "The Motor Oil Evaluater", http://themotoroilevaluator.com/members-blog/ which can also give you answers.
no
because it is only called motor oil by morons who don't know the true difference between a motor and a engine your right it should never be called motor oil unless it is a dc motor that has oil in it but for a engine ran auto it is engine oil
That is a very common problem with the Vortec engines. You must REPLACE the Intake gasket and then change the oil and filter a few times in a roll after letting the engine run a few minutes each time until you get the engine oil to clean up.
Motor oil
To check the oil on bikes you normally have to run the engine for a few minutes, the turn it off and let it sit for a few more minutes, and check the oil with the bike standing straight up.