The Crank Case is dirty. Use a good Crank Case cleaner to solve problem like Motor Medic Motor Flush. Warm engine 5 minutes and let clean out for 5 to 7 minutes. Then drain and use fresh oil.
the check engine light has to be cleared with the scanner, that wipes out the codes and resets. Answered by Littlestown Lube & Brake Littlestown, PA 717-359-5022 light will still be on. Black tape on dash light, best solution i can find.
I am still waiting for an answer. The book says on 1999 and newer Taurus's the engine and transaxle must be removed underneath the vehicle to change motor mounts. You will need a hoist and engine cradle. Big Job! Check with a proffessional.
Check Engine lights tell you you need to diagnose and engine problem, not change a gas cap. Gas cap do not register on the engines computer ECM (Engine Control Module). If your "Check Engine" light is on you probably need a tune-up or some sensor is malfunctioning. Take it to your local mechanic for a diagnostics.
Yes, they still do the FREE computer check. I just called in CA and the answer was "Not in California"
To reset the check engine light unplug the battery for 30 minutes. If the issues still persists the light will still light up when reattached.
Yeah, it can. If something is wrong with your emmision control system, your car can still fail emmisons, but the check engine light doesn't have to be on.
Check the engine oil, sometimes when the oil is low the check engine light comes on while sitting still and goes out when you accelarate.
VTEC may or may not work when the check engine light is on. It depends on why the check engine light is one. If it is on because of a problem with the VTEC system, then, no, it will not work properly.
Go to Auto Zone and they will check you engine light for FREE... And go from there...
Yes. The code should still be there.
i have a 2007 carolla that has been fully services and the check engine light is still on. there is nothing wrong with it.. How do I get it off?
There is no reset button for the check engine light. It must be reset with an OBD scan tool.