0
Not necessarily. However it would be advisable to replace the lifters and timing chain while you're in there. This is also a great time to upgrade the pushrods and rockers.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you fix blow by on 350 chev engine?
You must replace the piston rings. That means TIME FOR A REBUILD.
How much to rebuild a 1976 corvette 350 engine?
About $1700.
Are the camshaft bearings in a Chevy 350 engine all the same?
yes
How do you replace the camshaft in your 350 engine?
Most of the time, you gotta pull it. The whole engine's gotta come out. The camshaft will have to slide out the front of the block. It's a whole lotta work.no you dont have to pull it allyou have to do is take your radiator out then your grill yhen you can continue taking out the cam
What holds a Chevrolet 350 camshaft in place?
The camshaft of a 350 Chevrolet engine is held in place by a retaining plate or the lifters. The retention method depends on whether the cam is a roller or flat tappet design.
How long does it take to rebuild an engine?
Depends on the type and make of engine, your expertise and the tools available. I could totally dismantle and rebuild a lawnmower engine in a day, - a Chevy 350 took me a little longer.
What happens if you mix up the pushrods when assembling a Chevrolet 350 engine rebuild?
Nothing. They are all the same length
How much would it cost to rebuild a 1978 Z28 Camaro engine 350?
i just rebuilt a 350 cost with head work $600.00 and it was done right greg
How much does a Chevy 350 engine block weigh?
A bare Chevy 350 engine block weighs about 200 to 250 pounds. When you add in the crankshaft, camshaft, headers, and the intake it is more like 500 to 550 pounds.
Is a carbuater Chevy 350 camshaft different from a throtle body Chevy 350 camshaft?
Yes, there would be subtle differences, but they are interchangeable.
Can you replace the 350 engine in a 1981 silverado with a crate motor?
yes.
What would make the camshaft on your 350 Chevy move in and out when you turn the distributor?
That is because of the way the gear on the distributor and camshaft is tapered. If you turn it the other way it will pull the camshaft towards the rear of the engine. That is all normal. When you put it all together it won't do that.
