No, you dont have too. As long as the harness is the same.
either change the K-frame or use engine plates to bolt the engine in.
The 1993 engine will not fit directly into the 1986 frame without modification due to a 1992 change in frame geometry and mounting positions.
yes it will but you need to change the front brackets up
It will fit but you will have to change the K-frame or you could mount the engine in solid with engine plates.
f**k HONDAS! get an American made car......
look at the number on the frame, it is either stamped into the side close to the engine, or it is on the frame under the handlebars If the engine was replaced as mine was then the numbers on the frame will not tell you if you have a later or earlier model engine.
The VIN number is not located on the engine, it is as a rule located on the front of the bike frame. The engine has the engine number, which is different from the frame or VIN number. Look for it on the top front of the frame, just below or to the rear of where the handlebars column is placed in the frame.
either change the k-frame or use motor plates to mount the engine.
No. Frame number and engine number are two differrnt things )
The frame supports the vehicle. Everything bolts to the frame. The body, engine,etc...
how do you change a frame for a full side van
Just pull the old engine out and install a new one , you have to change motor mounts or the K-frame if you go to a bigger engine.