you press the unlock button. it is generally orange and says 'press' located on the part you click the seatbelt into. If the belt won't pull out, you will need to replace it.
Lock your door, and put on your seatbelt.
Yes you have to.
To fix a seatbelt that won't pull out, make sure it is not twisted. Jerk on the belt gently and let it retract before trying to pull it out again.
Check all of the fuses to see if it blew a fuse, If you want to remove the seatbelt, pull the plastic cover and there are bolts inside to remove them. If you want to simply disconnect the electrical part, there is a connector under the sear.
Apparently there is a major problem with these seatbelt doing this. You'll probably need to replace the whole unit.
It varies by state, but typically children over a certain age, like 18 or 13, are allowed to travel in the back seat without a seatbelt in some areas. However, it is always safest for everyone to wear a seatbelt regardless of age or seating position.
On the outside top edge of each back seat there is a knob which needs to be pulled upwards to release the lock. Similarly once in the 'down' position you need to pull the knob to release the lock. On the outside top edge of each back seat there is a knob which needs to be pulled upwards to release the lock. Similarly once in the 'down' position you need to pull the knob to release the lock.
You need a steering lock plate compressor that you can rent from the parts store. But take the steering wheel off {sometimes you need a puller} then the lock plate then the turn signal switch then there is one screw holding the lock in which is just below the lock assy. and has a different head. Take it out and remove the key reminder contacts then pull the lock cylinder out.
remove inner door panel for access to lock
you look where the seatbelt touches the ceiling and pull it down
if it is the ignition lock cylinder, first disconnect the battery, you need to remove the steering wheel ,turn signal switch , etc, then you need to insert the ignition key into the lock cylinder, turn it to the run position,then pull the cylinder out, reverse the operation to install the cylinder,