answersLogoWhite

0


Best Answer

If you're a big dude, yes.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Do you need to raise truck to remove starter on 1985 ford 4x4 truck?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the starter on a 1985 Chevrolet Silverado C20 Pickup?

Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter


How do you replace a starter in a 1985 Olds 98?

To replace a starter in a 1985 Olds car, raise the front end of the car with a jack, Next, remove the two support bracket bolts at the transmission and pry the support bracket away slightly to obtain access to the starter bolts.


How do you remove a starter from a 1985 Chevy 3500?

with a hammer


Where is the starter on a 1985 Nissan pickup truck?

look by passenger tire by oil filter


How do you remove a starter out of a 1985 Chevy Blazer?

Take the positive cable off the battery, then you have to remove the inspection shield on the transmission and then take the two bolts out of the starter


How do you replace starter on 1985 Chevy Celebrity?

To change the starter on a 1985 Chevy Celebrity: 1. Disconnect the battery ground. Use gloves to avoid getting battery acid on your skin. 2. Raise the car and put on stands. Be sure the parking brake is on. 3. Remove the wires to the starter solenoid. Take note of their routing . 4. Some starters have a brace at the front of the starter, remove it if present. 5. Using an appropriate socket remove the two bolts that hold the starter in place. There may be shims on the starter, if present save them for re use. The starter should now pull forward and then lower it from the engine. Replacement is the reverse of the above.


How do you change the starter on a 1985 Mercury Topaz?

Disconnect the battery. The vehicle will probably have to be raised to reach the starter. The starter has two or three bolts holding it in, and wiring attached. Remove the wires remembering where to put them back. Remove the bolts and pull starter out.


Where is the fuel filter located in a 1985 Toyota 4 runner?

Passanger side, above the starter. You have to remove the starter (don't detatch any wireing, just the 2 bolts). Once you have the starter out of the way, you can remove the fuel filter. Good luck, it's a PAIN!


What wires coming off the firewall connect to the alternator and starter on a 1985 Silverado truck?

about 2 wires with fusible links in them running from divers firewall to passenger side starter behind engine block.


How do you remove the starter from a 1985 Toyota Corolla GTS?

i don't know if the engines are similar enough for me to answer you question but i have a '85 sr5 and when i took off my starter, all i had to do was remove two bolts from behind the starter. you really gotta get down and dirty because they are BACK THERE! hope this helps you out.


How do you remove starter bendix 0n 1985 harley Davidson fxr?

how do i replace the bendix drive in my 85 harley fxrs


How do I remove a starter from a 1985 Vanagon?

Before removing any wires, be sure to disconnect the negative terminal from the battery. Label all of the wires that go to the starter and then remove them. Take a photo if possible to avoid any confusion. The starter mounts with two bolts. Simply remove the bolts and wiggle the starter loose. Once it is loose remove the bolts and pull the starter away from the engine to remove it. Installation is the opposite of removal. Be sure to inspect the starter bushing and add a little bit of all purpose grease if necessary. Fastener torque for the mounting bolts is 21ft/lb.