you have to remove the entire head-light/turn-signal assembly to get to the bulbs. There are these plastic clips on either side of the ENTIRE asembly, just pull them up and the entire assembly comes free. Remove the rubber stoppers on the back and then you need to twist the bulb housing to remove it from the asembly. The bulbs themselves just pull out.
I have a 95 and I believe the headlight housings will be swapped out in the same manor. There are plastic covers under the hood that protect the back side and wiring of the headlights. You must remove these. Then you will see 3 circular plastic pieces with bolt ends protruding from them which are used to adjust the headlight direction. They will have metal clips that hold the plastic pieces in place. They each have 2 holes which need to be spread apart, this will allow you to pull up on the clips and remove them. Now you can remove the headlight housings.
You have to remove the front bumper and remove the head lamp. then two plastic covers on the back of the assembly.
You have to remove the front bumper and remove the head lamp. then two plastic covers on the back of the assembly.
You have to remove the entire headlight assembly. Glass cover clips on with plastic clips. Remove and install CAREFULLY as glass breaks easily.
It pulls off. Sometimes easier to remove the headlight assembly to change the bulb. We have instructions at our forum. www.trailvoy.com Trailblazer enthusiasts!
unscrew them
look in the owners manual very helpful book. or remove plastic cover and twist plastic cover where build is
you have to pop the hood, DON'T take off the plastic! remove the light from the back
We have detailed headlight change procedures at our enthusiasts forum www.trailvoy.com
If they aren't severe, try Meguiar's Plastic Glaze.
open the hood, remove 3 screws on each headlight and pull the headlight straight out, unscrew the black plastic cap, loosen spring retainer but don't remove it. install new bulb and put it back together.
To change the headlight on a 1985 Honda Spree scooter remove the headlight housing. The scooter headlight will be mounting on the rear of the housing. Remove it and replace the bulb.