Can not be determined due to not describing what it is.
i need help tacking out a broken off distributor
The only one I know of that check ur temperature is the Sensor and it is located under the distributor...to the left of the cylinder. it is underneath and has a wire going to it....you need a wrench to take it off but might need to take hte distributor off too.
you need to take it off an look to see if it is fouled down(black marks)
Remove distributor cap Either lift off rotor or unscrew and lift off is so equipped
all you should have to do is take the distributor cap off, and there it is. answer take the distributor cap off, pull the old rotor off, put the new one on, put the cap back on.
3 bolts on distributor, take off valve cover 13 mm on distributor 12 or 11 mm on cover
you take off carb or tbi and the take off all braces from intake. take out distributor and coil(you will need them later) and then take all the fastener bolts of and replace intake. put all of the things back on
I'm trying to do a tuneup on my 89' 740 Volvo with turbo. Having problems getting the distributor rotor off?
Take the distributor cap off and turn the engine. If the rotor turns it's not "stuck".
Take the distributor cap off an crank the engine or turn the engine by hand clockwise and note the direction of the distributor rotor.
It's either your timing is off or you have to take the distributor cap off and set the timing again once you turn the crankshaft pulley where it is suppose to be at and set the rotor on the distributor but let me ask you if you have mess with the timing belts or the distributor cap or u took the distributor off or what?
The only tool that is really needed to remove the distributer cap off of 1994 Mazda Protege is a screwdriver. Using this tool will enable you to loosen the cap, and then you can remove it.