answersLogoWhite

0


Best Answer

Turn the engine until the #1 plug is at TDC on the compression stroke. Mark the distributor at that location. Install the new distributor and turn until you are at the exact same location. Have the timing checked after you get it started.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Does 1993 colt 1.5 to install a distributor Does 1 need to TC on compression stroke?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you install 1993 rodeo distributor?

install distributor rodeo 1993


What are the proper timing procedures for a 1993 4.3 liter?

you need to bring cylinder 1 piston up to top dead center on compression stroke then turning the oil pump drive shaft so the distributor rotor faces #1 on the distributor cap.


How do you install 1993 eclipse distributor 1.8 engine?

Easy....Read the manual.


Where is distributor cap on 93 Chrysler intrepid?

A 1993 Intrepid does not have a distributor cap.A 1993 Intrepid does not have a distributor cap.


Is a 1993 Polaris 350 a 4 stroke or a 2 stroke?

A 1993 ploaris 350 is a two stroke/


Where is the distributor on a 1993 Corvette?

The distributor is on the front of the engine.


What are the numbers on the distributor for a 1993 Honda Civic LX?

what are the numbers on the distributor for a 1993 Honda civic LX


Is the 1993 Honda xr100r a 2 stroke or a 4 stroke engine?

A 1993 Honda xr100r would have a four stroke engine.


Where is the distrbutor cap on a 1993 stealth?

there is no distributor cap nor distributor


Is a 1993 250 trail boss a 2 stroke or a 4 stroke?

2 stroke


What are the release dates for Stroke - 1993 I?

Stroke - 1993 I was released on: New Zealand: 1993 USA: October 1994 (Chicago International Film Festival)


Where is 1 located on the distributor cap for a 1993 305 caprice?

Firing order is 1-8-4-3-6-5-7-2. Distributor rotates clockwise. Number 1 cylinder is front of engine driver's side. Remove all the spark plugs and disconnect the coil wire, and turn the engine by hand until the #1 piston is at Top Dead Center, (TDC) on the compression stroke. Remove the distributor cap and look at the rotor. It will be pointing to the # 1 plug position. The next plug will be # 8 going clockwise, and so on.