The automatic transmission fluid temperature sensor on a 1997 Chevy Blazer S10 is located on top of the transfer case. It is in the engine compartment.
That would be the 4L60E
Assuming you have an automatic transmission the dipstick is located under the hood on the passenger side in back of the engine, close to the firewall.
There are 6 bolts that hold the trans. to the engine block.
Will a Chevy blazer engine fit in a Chevy s10 pickup
That would be the 4L60E transmission.
Will a 1997 blazer what work on a 1999 blazer????? If your talking engine, transmission, or running gear than yes. It is all the same.
There are many bolts that assemble a transmission, automatic or standard. Be more specific.
700 R4 if it is automatic. 2x2
Depends on which engine it has and if it is a standard or an automatic.
No, different bolt pattern.
The transmission dipstick on a 1998 Blazer should be located at the rear of the engine. It should not be near the oil dipstick.
That would be a 4L80E automatic transmission.
The 1996 Chevrolet blazer transmission control system helps the transmission to maximize optimal fuel consumption. The control system keeps the transmission in the overdrive gear.
can I put a 99 Chevy 4l60e transmission in my 86 k5 chevy blazer
The transmission fluid on a Chevy Blazer can be checked by idling the engine and allowing it to reach operating temperature. The dip stick can then be removed and checked based on the markings provided.
Located inside the transmission Check auto zone.com repair section
On the driver's side of the transmission (range select cable is attached to it).
Yes, they both had the same transmission options.
That is a 350 engine.