Ford Taurus
Dodge Ram
Pontiac Trans Am
Mitsubishi Montero, Pajero, and Shogun

Does anyone know what will keep a 97 Taurus from shifting into overdrive all other gears shift properly you have changed the trans range sensor and the throttle positioning sensor and trans fluid can?

131415

Top Answer
User Avatar
Wiki User
2006-05-26 05:13:47
2006-05-26 05:13:47

OD is achieved when the OD band holds the front planetary sun gear stationary. This is done by the OD servo and piston assembly, when fluid is directed there through a valve in the valve body. You could have a problem in any of those areas causing you not to have OD. The bottom line is, that transmssion is going to have to be dissassembled to fix your issue.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The throttle positioning sensor is located in the throttle body.

User Avatar

On the throttle body attached to the throttle butterfly shaft.

User Avatar

The throttle position sensor is on the throttle shaft, on the throttle body.

User Avatar

It is on the throttle boby, opposite the cables.

User Avatar

The throttle position sensor is mounted on the side of the throttle body

User Avatar

the sensor is black an it is on the side of the throttle body at throttle plate!!

User Avatar

the throttle position sensor is located on the side of the throttle body

User Avatar

Here is a link... With pictures of throttle positioning sensor... http://www.thepartsbin.com/repsite/ford~throttle_position_sensor~reparts.html

User Avatar

The wrench symbol stands for a problem in the throttle system. Maybe the throttle body or the throttle positioning sensor.

User Avatar

It. is on the throttle body, opposite of where the cables attach.

User Avatar

under the throttle body next to the thermosat housing.

User Avatar

there are many different things that it could be check the camshaft positioning sensor, the throttle positioning sensor, and the crankshaft positioning sensor.

User Avatar

If the TPS or Throttle Positioning Sensor goes bad on a 2004 GMC Envoy SUV, the car will have a very rough idle. The engine might stall frequently and the cruise control will not function properly. The car will also use much more fuel than is necessary.

User Avatar

The transmission shifting is late because the kick-down cable needs to be adjusted. The kick-down cable is usually found on the throttle lever with the throttle cable.

User Avatar

The Toyota Tacoma throttle position sensor is adjustable. There is an adjustment screw on the back of the throttle position sensor.

User Avatar

it is black,located at throttle plate, on side of throttle body.is held on by screws.

User Avatar

its right on the throttle body itself, its black and has 2 bolts holding it on.

User Avatar

The 1999 Ford Ranger 3.0 liter engine throttle positioning sensor is located on the cylinder head. The sensor will be near the middle of the cylinder head.

User Avatar

A throttle position sensor is a sensor used to monitor the position of the throttle in an engine. The sensor is usually located on the throttle-body spindle so that it can directly monitor the position of the throttle valve butterfly.

User Avatar

If it is similar to the 2002, and I believe they are, It is permanently attached to the throttle body. To replace the sensor, you have to replace the whole throttle body.

User Avatar

Maybe your throttle positioning sensor is bad.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.