Want this question answered?
Yes, you can get your brake line repaired at Midas, Car X, Firestone, Goodyear which is really good with fixing brake lines and you can also take your car into the dealership.
You can not use rubber fuel lines to replace the current brake lines due to the high operating pressure. You will need to replace them with brake lines, the rubber brake lines has a different construction to hold the pressure and not getting eaten away by the brake fluid, brake lines can hold over 2000psi when the pedal is heavily applied
Master cylinder brake lines are the most common brake lines on a the Chevy Malibu.
After the car crash he is said to have "numerous injuries" and almost dies - Ruby admits to cutting the brake lines, but did not intend for him to get hurt
You remove the wheels to replace brake lines.
The brake lines can be replaced by removing all of the retaining clips. The brake lines will need to be disconnected on both ends. Reverse the process to install the new brake lines.
Brake lines run from the master brake cylinder to each wheel, generally under the frame of the car.
Why would you want to replace all the brake lines? You can flush the entire system and install fresh DOT3 brake fluid. I can see no reason to replace all the brake lines. Why are you doing this? Unless your brake lines are rotted out or someone has cut them... there is no reason to replace all four lines.
How to change brake lines on a 1991 Buick Lesabre?
The service brake is the one which applies the brakes - the emergency brake system is the system which releases the spring brakes.
It sounds like you have air in your brake lines. It sounds like you have air in your brake lines.
need diagram of rear brake lines for 1993 mercury topaz