t64k-44890-b
Yes you do have to remove the bars or at least the torsion bar cross member and to do that you either need the otc tool or use a two jaw puller make sure to measure the bolt height before you start and set it the same they control your ride height
Ford didnt make a Fusion till 2006
If you can not remove fasteners from outside of trunk you must make a cut-out inside of trunk so you can get your hand to access bulbs.
The year, make and model info would help.
MOST Torsion Bars have an adjustment bolt 2 set the ride height-IF so-back off the adjustment until u can move the arm by hand up & down-MAKE sure u measure the ride height B 4 U start & measure the amout of threads on the adjustment & B Very Careful that ALL the TENSION is OFF>
To make a sentence trunk, you can start by identifying the main idea of the sentence and keeping only the essential information. Remove any unnecessary words or phrases that don't contribute to the meaning of the sentence. Keep the sentence clear, concise, and focused on the central message.
300M (ww.ovako.com)
It isn't difficult to remove the inside part of the trunk from a 2004 Honda Odyssey. However, you will need the repair manual for your specific car. Make sure to follow the directions so you don't break the trim panel.
Yes. Look inside the glove compartment. There should be two buttons. The yellow one is your trunk release. Make sure the key is in the ignition, also.
MAKE SURE THE WIRE DIDN'T COME DISCOBNBNECTED.
First jack the truck up and put a jack stand under the frame, MAKE IT SAFE now Loosen the torsion bar adjusting bolt all the way with out removing the bolt completely. be sure you count the turns you take on the bolt, and record it. You will need info later. Now remove wheel and put a floor jack under the lower control arm close to the ball joint. Now take the nut off the lower ball joint, Now raise the hub assy. and rotor up and off the lower ball joint and wedge a block of wood in some were to hold it in place, out of the way. You will have to remove bottom bolt in the shock. Now remove the torsion bar adjusting bolt, and count the rest of the turns it takes to remove the bolt and add that to your first count, and record it. When putting bolt back in later, TURN BOLT SAME # OF TURNS BACK IN THAT YOU RECORDED EARLYER Now remove lower control arm bolts and mark the torsion bar were it goes into the lower control arm, remove control arm and torsion bar at the same time as a unit. Lay on floor and slide bar out.
Make sure that you have torsion bars.i believe that you coil springs.your best bet is to find a leveling kit to keep a nice ride.