0
No.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is crankshaft sensor on 2006 dodge diesel?
Front of engine, reads off a a tone wheel behind the crankshaft pulley.
How do you remove the crankshaft pulley in 1994 Lexus gs300?
Undo the crankshaft pulley bolt { anti clockwise } Then you will need a good strong puller to remove it. or try to move it by tapping the back of if fairly hard until it comes off.
How do you take off crankshaft pulley on 2 liter diesel year 2001 without the engine turning?
Use a strap wrench or chain wrench on the pulley to hold it secure.
How can you get a crankshaft pulley off a 03 dodge stratus 2.4L engine?
You need a special tool to remove the crankshaft pulley on a 2003 Dodge Stratus. The correct tool is OTC Tool No. 6075. If you don't want to buy one, you can rent one from an AutoZone store.
Why has the tip of the crankshaft of a 1992 B2200 Mazda pickup with an F2 engine broken off twice during 89000 miles?
The most logical reason for the key or tip as you call it breaking off is probably a result of improper torque on the crankshaft pulley or the crankshaft pulley is out of balance.To prevent this I would highly suggest buying a new crankshaft pulley that will be balanced.To explain what happens over time the strain of adjusting the belts from the alternator and power steering and air condition pull the crankshaft pulley with varied tension and can cause the crank pulley to warp to a degree causing it to be unbalanced.While this may seem a bit strange the metal will be affected by this due to age,temperature,torque from the belts tensions pulley left and right.Best bet buy a new crankshaft pulley (note just look at the pulley while idling and see if is wobbling) this will tell you the pulley is warped or out of balance.Plain and simple!
Can you weld the crankshaft pulley onto the crankshaft of a 1995 Honda civic The bolt came loose and broke the 'key' and stripped all the teeth off the pulley and end of crankshaft1.5L?
why not get a new motor why not get a new motor ANSWER by welding on the crankshaft while it is still assembled to the engine will most likely melt your seals thus causing you to replace the seals.
What is the other big pulley that's alongside the crankshaft pulley on a 1992 Honda Accord It's frozen but doesn't seem to affect the engine when it's running.?
Smog pump pulley - are there two hoses running off the back somewhere? then it would be the smog pump (recirs engine gases in the crankcase)
How do you take a crankshaft pulley off of a 1996 mercury mystique?
Jack the motor up and take the motor mount loose on the top right side. Carefully lower the motor down until you see the crankshaft bolt on the bottom. Then take the center bolt off the crankshaft and then the pulley will come off.
You have removed the crankshaft pulley nut but pulley will not come off?
You may need a pulley (aka gear) puller to pull it off of the crank. The puller comes usually with bolts or claws you can ancor onto the pulley...
Having a hard time removing a crankshaft pulley off a 2000 dodge neon?
You have to purchase a special pulley puller from Dodge, other wise you will break the pulley when you try to pull it off.
What causes serpentine belt to run off crankshaft pulley 99 olds cutlass 3100?
Bent, Broken, or misaligned pulley
What is the bottom pulley on a Chevrolet 350?
The "bottom" pulley is typically the one that is driven off the crankshaft. It's called the "harmonic balancer".
