Its in the fuse block - underhood.......
The AC clutch cannot be replaced without physically removing the compressor on a 1997 Mercury Sable. The compressor and magnetic plate must be removed before you can access the clutch.
I am sure you can - but the clutch is abpout the same price as a rebuilt compressor. So last time i did this I bought the compressor, removed the cluth, and put it on my car compressor. I still have a compressor if I need one. Be sure your compressor is not locked up before you go buy anything.
The clutch has a bolt or nut in the center, connecting it to the compressor. After the nut is removed, the clutch can be removed by use of a gear puller.
The ac clutch is held on with a single nut, and can be removed with a remover tool. It the tool will not fit in the space available, then the entire compressor will have to be removed to replace the clutch.
The AC clutch on a ford FS-10 is mounted on the front of the compressor. The clutch is removed by using a puller after the clutch nut is taken off. Mount the puller, and turn the center bolt. This will pull the clutch off of the compressor shaft.
If the clutch disengages properly then the compressor should not be running. Most likely the clutch itself is bad instead of the compressor.
The ac compressor clutch is mounted on the front of the compressor and is a replaceable part. However depending on the complexity of the clutch change out it may be overall better to change the compressor and clutch together.
The AC clutch is on the front of the compressor where the belt rides. When power is applied to the clutch it engages to turn the compressor. It is basically a magnet a/c compressor clutch is the ound thing on the front of the compressor with pulley wheel attached. this clutch is an electro magnetic clutch that when electricity is supplied, engages so as the a/c compressor is driven ,which can then pump freon thru the ac system
I need to know the type of compressor (make) before I can answer that question.
It should be right on the front of the compressor - usually the clutch is inside the v-belt/serpentine pulley on the compressor
Bad A/C compressor clutch. Bad A/C compressor clutch.
AC Compressor clutch relay may be stuck. Remove the relay and see if the clutch releases.
how do you replace the AC compressor clutch on 2006 liberty
If the AC pulley is locking up when the ac compressor clutch engages, it's not a clutch problem, it's a compressor problem. But yes, the AC clutch can usually be replaced separately. The problem is, if the clutch is worn out the compressor is probably worn out as well. It usually isn't that much more to replace the whole thing.
My car is going through the same issue with the A/C. You CAN replace the compressor clutch without replacing the compressor, but the caveat is that you can't tell if the compressor is any good without a clutch. So basically you are gambling that the compressor will still be good by only replacing the clutch. Hope this helps!
The clutch bearing for an AC compressor is located in the center of the clutch. If the bearing goes bad, then the clutch is replaced as a whole part rather than changing the bearing.
The compressor should be removed with the bracket that holds it and then removed from the bracket once out of the engine bay. There is a small bracket that mounts on the front underside of the clutch that needs to be removed first (two bolts and one stud) then four bolts and one stud for the main compressor bracket.
It's a 36mm
no, unless u have to remove the compressor unit. The clutch can be replaced with out removing the compressor if you have room to do it.
The air conditioning compressor clutch relay is located on the bottom of the air conditioner compressor. The relay switch will be labeled.
You may have a bad compressor clutch coil, you need to check the coil and work from there................
there are three bolts under the transmission case by the converter clutch butterfly valve take them off and its under there but make sure you have completely removed the gasket
Oiling the a/c clutch will cause the clutch to slip and burn up........
ac compressor was working fine before one of the seals blew and i lost gas.Pulled a vacuum on the system and put in new gas.Now my compressor clutch is no longer working.Checked the relay switch and it is fine.Not quite sure what the compressor diode does so not sure if that's the problem or if for some reason my compressor went bad all of a sudden?