Ford Explorer
Chrysler LeBaron
Toyota RAV4
VW Cabrio

Does the power windows in a Chrysler LeBaron GTC 1989 require a fuse?

272829

Top Answer
User Avatar
Wiki User
2006-02-26 07:30:40
2006-02-26 07:30:40

YES! Everything that is electrical in nature on any vehicle is protected by a fuse, a fusible link or a circuit breaker. Find your fuse panel and each fuse should be labeled as to what circuit it protects. Be sure to replace any fuse that burns out with one of the same amperage. If the fuse keeps burning out it is doing what it was designed to do--protecting against overheating and a possible fire. If the fuse keeps burning out there is a short in that circuit that needs to be located and repaired as soon as possible.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

How do you manually raise the power windows on chrysler sebring?

User Avatar

There could be a few things on a 1995 Chrysler LeBaron causing the distributor not to have power. But first I would check the spark plugs and see if maybe they have gone bad.

User Avatar

how to repair passenger side window on a1986 Chrysler le baron

User Avatar

You have to remove the back seats.. and then the panels.. windows are held in by 10mm bolts.. disconnect the connectors at the bottom if the window unit.. Allow an hour to do this.. PIA job

User Avatar

Power windows were introduced with the 1951 Chrysler Imperial.

User Avatar

plain old power steering fluid is the recommended type

User Avatar

A 78 Lebaron does not have a serpentine belt. It has Separate belts for the alternator, power steering, AC/Water pump and Smog Pump.

User Avatar

A Chrysler Sebring does not have any reset switches.

User Avatar

It is just like a check engine light. It comes on when the computer detects a malfunction.

User Avatar

its at the back of the engine.. located under the dipstic/ filler tube to the right of the alternator

User Avatar

pump..?? behind the engine left side.. follow the filler tube donw you'll find it..

User Avatar

That is the same as the check engine light. See related questions below.

User Avatar

Power steering fluid is added to the power steering fluid container. It is located under the hood of this car, with a lid stamped with 'Power Steering'.

User Avatar

Under the hood in the power distribution center. On the inside cover is a layout of the location.

User Avatar

near the power steering fluid holder.. its a round discy lookin thing with a couple of pipes attached to it..

User Avatar

In the trunk. The power steering fluid reservoir should instead be filled with Mopar ATF+3 or equivalent meeting the +3 standard.

User Avatar

The 2013 Chrysler 200 is 6 ft. 0.5 in. (72.5 in.)1 one-touch power windows wide.

User Avatar

The 2015 Chrysler 200 is 6 ft. 0.5 in. (72.5 in.)1 one-touch power windows wide.

User Avatar

The 2005 Chrysler 300 is 6 ft. 2.1 in. (74.1 in.)1 one-touch power windows wide.

User Avatar

The 2012 Chrysler 200 is 6 ft. 0.5 in. (72.5 in.)1 one-touch power windows wide.

User Avatar

The 2014 Chrysler 200 is 6 ft. 0.5 in. (72.5 in.)1 one-touch power windows wide.

User Avatar

The 2006 Chrysler 300 is 6 ft. 2.1 in. (74.1 in.)1 one-touch power windows wide.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.