0
Fuel Level sending unit is ok but I have the light on dash on empty tank and level mark on the dash for quantity of gaz in the tankis empty but I have half tank?
Vieira
Look for a bad grounding wire. If the fule gauge sending unti is properly gounded, it should send the signal to the fuel gauge, make sure the fuel gauge is grounded. You may have a bad fuel gauge.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
What is the ohm reading for a 2003 Chevy S10 fuel level sending unit?
The reading will vary from empty to full.
What are the ohm levels for the fuel level sending unit in a 1993 240sx?
78-84.8 ohms empty 4.3-5.8 Full
Is empty an adjective of quantity?
yes it is
2001 Chevy s10 fuel gauge drops to empty at an idle what causes that?
needs a fuel level sending unit 100 percent sure
2000 Yukon gas gauge sometimes shows correct level and sometimes shows empty when full What could be the problem?
My 2001 had the same problem. There is a GM recall to replace the sending unit.
2000 silverado sHow is empty when full?
bad sending unit in tank.
Your fuel gauge is registering empty after a rear impact collisioneven though there is fuel in the tank why?
More than likely the fuel level sending unit has been damaged or the wiring may be damaged or disconnected.
Can you die if you drink water fastly on a empty stomach?
You can, but you have to drink a ridiculously large amount. A normal quantity of water will do you no harm, whether on an empty stomach or not.
What is the range of resistance of the fuel level sending unit on a 90-93 Ford Festiva?
Full position (up) - 7 ohms Half tank (middle) - 33 ohms Empty position (down) - 95 ohms
Why does your Chevy silverado 1500 gas gauge keep on empty when it has gas in it?
Bad fuel level sending unit.It is located in gas tank.Tank must ne dropped to replace.Can get units from local auto parts stores.
What is the OHMS rating for a 1973 Datsun 620 pick up truck fuel sending unit empty and full?
full 10 ohmss empty 80 ohms
What causes Gas gauge on a 1997 Monte Carlo to always read empty?
no power at the sending unit.
