0
Harley If you replace a 4 speed trans with a 5 speed trans do you need to replace the clutch as well?
Wiki User
∙ 16y ago
It's usually a good rule of thumb that if you replace the trans, you replace the clutch.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How would you replace fifth gear syncro or can you just replace the clutch?
5th gear synro is inside the trans... the clutch has nothing to do with it.
How do you remove the hydraulic clutch cable from the transmission on a 93 Ford Ranger 5 speed trans?
The hydraulic clutch slave cylinder is located on the mainshaft of the trans. You must remove the trans to get to it
How do you replace clutch 1980 Nissan 280zx?
pull the drive shaft the trans cross member the trans and its right there
How do you replace the clutch plate 1993 Ford Explorer?
First you un bolt the trans move it back Then unbolt the clutch remove the pressure plate replace it the put the clutch back on put the trans back bolt it and there u go and u have to un bolt the drive shaft first
How do you replace the clutch slave cylinder on a 1996 C2500 Chevy Cheyenne 350 motor w 5 speed manual tran do you have to remove the trans?
Yes you do. It is inside of the bell housing.
What should it cost for clutch replacement on a 2001 rav4?
Parts,$300 and the book time for a 4x4 Rav is 12hrs as the engine/trans have to come out as a unit to replace the clutch.
How do you change the clutch on a 1989 Toyota MR2 turbo?
Take the trans out, the clutch is inside the trans ^_^
Can you use a 1986 Trans Am 5 speed tranny with a 1974 Chevy 350 motor What flywheel would you have to use?
You have to use the flywheel for the 1974 engine and the clutch plate for the Trans Am.
What steps do you take to remove and replace the master clutch cylinder of a 1992 Ford Ranger?
If you need to replace the slave cylinder it is located in the bell housing and the trans has to be removed. The clutch master cylinder is located on the firewall on the drivers side
Do you have to disconnect the drive shafts to replace the clutch and pressure plate 0f a 1989 Mazda 626 5 speed?
yes, u need to disconnect drive shafts to enable you to remove trans mission to get at cluth and pressure plate
You have a 1993 Geo Storm and the clutch is very tight What do you need to do?
adjust the clutch cable on top of the trans. adjust the clutch cable on top of the trans.
How do you replace a clutch in a 1986 ranger with a 2.9?
pull the trans take out the old clutch and put a new one in then put it back together. or do what i do i buy a book on my ranger and fix it myself
