The crankshaft sensor in your 1990 former Roche is located on the front of the engine. The best way to test your crankshaft sensor is to hook the engine to a Dyno tester.
The 1994 Lexus electronic ignition fuse is located in the fuse box. The electronic ignition fuse will be in the first column, third from the top.
It is located on the RH side Crankshaft Cover.
It is inside the distributor.
If this is the 4.3 engine, it is located on the bracket next to the ignition coil.
It uses a distributorless coil pack and a crankshaft trigger sensor.
Inside the steering column behind (connected too) the ignition key switch
1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.
where is the ignition control module located on mercury marquis
Actually , it doesn't have a distributor , it is EDIS ( Electronic Distributorless Ignition System )
The crankshaft position sensor on a 97 GM Sonoma 2.2 engine is located on the lower right side of the engine. It is near the ignition control module.
I don't think your car has a distributor cap. I believe it has an electronic ignition and only has an ignition coil to deliver spark to the plugs. Where this is located, I do not know.
The van should have electronic ignition, resistors are built into the ignition module and cannot be serviced. The module is located on the left inner fender below the master cylinder.