Car Computers and Sensors
Mercury Grand Marquis
Pontiac Grand Am
Crankshaft Sensors
How To

How to replace crankshaft position sensor on a 1983 mercury grand marquis 302 v8 engine?

567

Top Answer
User Avatar
Wiki User
2010-08-12 22:32:25
2010-08-12 22:32:25

1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

replace keypad Mercury Marquis?

User Avatar

How do you replace the orifice tube on a 2000 Mercury Marquis

User Avatar

How do you replace the timing chain on a 1994 mercury grand marquis

User Avatar

how to replace starter on 2000 mercury grand marquis

User Avatar

how do you get to and replace the wiper moter on a 97 marquis

User Avatar

Check out the related link for a video on how to replace a crankshaft position on a Ford Focus SE.

User Avatar

You don't, you replace or rebuild the engine.

User Avatar

how do you replace the front sway bar likn in a 1999 Grand Marquis?

User Avatar

how to replace the crankshaft position sensor located in a 2003 kia rio

User Avatar

You have to replace a whole thing, not only a cable

User Avatar

Replace the crankshaft and camshaft senors and then clear the codes with an oBD II engine scanner and that will fix it.

User Avatar

Replace your IAC Valve-No more stalling

User Avatar

On a 1997 Ford Taruas I was just quoated from Ford Dealer 375.00 labor plus parts

User Avatar

You have to remove and disassemble the engine to replace the crankshaft.If you mean the crankshaft position sensor, then yes. You access it from underneath. It is just above the oil pan on the back of the block.You have to remove and disassemble the engine to replace the crankshaft.If you mean the crankshaft position sensor, then yes. You access it from underneath. It is just above the oil pan on the back of the block.

User Avatar

where is the crankshaft position sensor on 2.5 liter vw jetta

User Avatar

The crankshaft position is on top of the transmission bell housing on the drivers side. The sensor can be replaced by unbolting and unhooking the plug.

User Avatar

it is on the firewall and difficult but not impossible to get to and replace.

User Avatar

Replace the flasher relay if none of them are working.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.