Highly unlikely. Might want to try one of the strap-type filter wrenches. Position it as high on the filter as possible where you can squeeze harder without deforming.
make sure that you are turning it counter clockwise
Most of the oil is in the pan, not the filter.
Yes, the filter holds less than a quart, while there will be over four quarts in the oil pan.
After removing the engine cover carefully remove the wiring harness for the sensor and fuel lines, Then the filter bracket complete with shroud, Spin out old filter then reverse process to complete.
Oil change is the process of cleaning the engine by removing dirt and other impurities from the oil filter.
Lube Oil Filter is another name mechanics use when performing an Oil Change service. The reason is that an Oil Change generally includes lubing various car joints, removing and replacing the engine oil and replacing the engine oil filter.
Start with replacing the fuel filter.
The oil plug can be reached by removing the splash guard underneath the engine. The oil filter is on top of the engine, on the driver's side, toward the firewall (rear).
The oil filter can be accessed by first removing the cover from the motor. The filter is then located at the front and center of the engine in a cylindrical compartment, below the black screw-off cap.
The fuel filter is located at the rear of the engine bay, at the top near the firewall. Take care removing and a special tool may be required.
The oil on a 2012 Mercedes E550 is changed by removing the drain plug under the engine, draining the oil, and removing the oil filter. The plugs is then reinstalled, a new filter put in place, and the oil filled to the correct level.
The cross reference hydraulic filter 86546618 New Holland hydraulic oil filter works with an sba140517020, even with this wix filter is set for a 40 - 45 HP engine. It is listed to work just fine down to a 35 HP engine with no trouble.
It is accessable from underneath the engine. There is a skid plate that protects the lower half of the engine from rocks and debris. There is an access panel in the skid plate. This opens by removing the 10mm bolts and rotating the panel out of the way. You can now see the oil filter up inside. You will need to do this with the vehicle up on ramps to access. Have a towel handy to pack under the oil filter. When you break the seal the oil will pour out of the filter and run everywhere. Another great design by GM having the filter sideways instead of up and down.