0
Help how do you remove a water pump from a 1990 pont sunbird 2.0l ohc you have loosened the retaining bolts and it still won't rotate so you can take the tension off the timing belt?
Wiki User
∙ 14y ago
1. Disconnect the negative battery cable. 2. Properly drain the cooling system into an approved container. 3. Remove all accessory drive belts or the serpentine belt. 4. Remove the alternator and bracket. 5. Unscrew the water pump pulley mounting bolts and then pull off the pulley. 6. Unfasten the mounting bolts, then remove the water pump. 7. Using a putty knife, clean the gasket mounting surfaces.
ALSO: on most vehicles you should take off the alternator as well, that way it will release the belt from getting in your way of removing the water pump.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you remove timing belt tensioner from a 1987 Pontiac sunbird?
After you have released the tension from the belt, remove the 2 obvious bolts that hold it to the engine block.
How do replace Belt Tension Adj - 1986-1993 Mercedes Benz 300E?
The belt tensioner pulley is held in place by a retaining bolt. The retaining bolt is in the center of the pulley. Remove the retaining bolt and the pulley will come off. Reverse the process to install the new pulley.
How do you change the accessory belt on an '87 Pontiac Sunbird?
On the main drive serpentine belt, there is a tensioner pulle. it is positioned at 6:00. relieve tension remove belt. reverse process for reinstallation.
How do you remove the dash board on a Chevy Lumina?
The Chevy Lumina dashboard is held in place with retaining bolts and retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
How do you remove the clutch on a 1991 prelude?
You will need to remove the transmission. Remove the clutch plate retaining bolts. Remove the clutch linkage. Remove the clutch retaining bolts.
Where is a tensioner pulley on a 1981 Oldsmobile omega?
When looking at the engine from the front, the tension pulley is the only wheel on the drive belt that has the belt on the inside of it. All of the other pulleys have the belt going around the top of the pulley. The tension pulley has a bolt that can be loosened and then tightened to remove the drive belt.
How do you remove the dashboard on a 1997 Chevy Cavalier?
The 1997 Chevy Cavalier dashboard is held in place with for retaining bolts and eight retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
How do you remove the dash on a 1995 Chevrolet Lumina?
The 1995 Chevrolet Lumina dashboard is held in place with for retaining bolts and 12 retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
How do you remove radio from 1997 Dodge Ram?
Remove the decorative radio retaining plate. Remove the radio retaining screws. Remove the wiring harness, from the back of the radio.
How to remove radio 1996 buick lesabre?
Remove the decorative radio retaining plate. Remove the retaining screws. Pull the radio out. Remove the wiring harness. Remove the antenna cable.
How do you remove front speakers in a Mitsuibishi Mirage?
Remove the speaker covers, by loosening the retaining screws. Remove the speaker retaining screws. Remove the wiring harness. The speakers will come out.
How do you remove door panels on a 2000 Buick century?
The 2000 Buick Century door panel is held in place with for retaining bolts and 10 retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
