Remove the fan shroud, remove the fan clutch, (a special tool is needed to remove the fan clutch, it may be loaned by your local auto parts store) It will come off turning counter-clockwise. remove the belt. you will need to drain the anti-freeze. Disconnect all hoses to the water pump, unbolt water pump and remove.
When installing a new water pump, be sure the mounting surface is clean and free of debr. Use a recommended gasket sealer and bolt back onto engine. Everything goes back together in the same sequince.
It should be on the front of the intake manifold directly above and behind the water pump.
Yes it will bolt right up to it.
The fuel lines around the filter; you will need an adapter.
.043
.43L. 1000ml=1L
Don't know what year you have but some sensors are temperature sensitive and you should run a 195 degree thermostat.
first check to see if your getting voltage to your fuel pump. go to the connector at the rear of the truck. check voltage. should have 12 volts. if you do have 12 volts your pump has gone bad. this happens some times. if you don`t have voltage find your fuel pump relay. (right side kick panel) see if it comes on. on some models the relay is built into the computer box. if it is in the computer box the computer box needs to be replaced. also check to see if your fuel pump fuze is blown.
4L60/E l
43L of 18-k gold
There is one before and one after the catalytic converter.
The EGR valve on your Astrovan is on the backside of the intake manifold just under the throttle body attached by two bolts. After installing a new gasket be sure and torque the BOLTS to 17-18ft lbs or the NUTS (if yours has studs) to 15ft lbs)
There is no adjustment required, but you can clean it with a carb cleaner.