It should be on the front of the intake manifold directly above and behind the water pump.
The EGR ( exhaust gas recirculation ) valve is located behind the throttle body on the passenger side.
Catalytic converters are located in the exhaust system between the engine and the muffler.
Where is the horn located on a 1993 chevy blazer
They are all threaded into the exhaust system at various points.
P0403 Exhaust Gas Recirculation Circuit Malfunction
Where is the control module located on the 1983 Chevy blazer
Where is the idle speed motor located at on a 1995 chevy blazer?
should be on the exhaust manifold
one on each cylinder bank and then before and after the cat converter. there all on the exhaust.
The tire jack is located in the rear inside of your Chevy blazer. The jack can be found in a side compartment.
Hey George==Get under the truck and it is on the left side of the engine above the exhaust pipe. goodluckJoe
That vehicle has several O2 sensors and they are all threaded into the exhaust system at various points.
I have a 1997 Chevy Blazer 4DR and the relay is located underneath the glove box.
It will be in the exhaust system about half the way back. It looks like a muffler but it will be before the muffler. It is closer to the engine.
The oil cap on a 1998 Chevy Blazer is located on the passenger side of the motor. It is just to the left of the manifold cover.
The ECM on a 1992 S10 Blazer is located below the glove box.
its a m10 1.50.
on the passenger side of the vehicle right under the exhaust manifold
The oil pressure switch on a 1998 Chevy Blazer is on the side of the engine block. It is located above the oil filter.
Trouble code P0404 means: Exhaust Gas Recirculation Control Circuit Range/Performance
The fuel gauge fuse on 1998 Chevy blazer is located in the front of the blazer. It is on the driver side next to the hook latch.
The bank 1 sensor 2 on a 1996 Chevy Blazer is mounted in the exhaust. Sensor two is just behind the catalytic converter.
They were not used on Chevy trucks.