To remove the fog light - firmly grasp the black plastic lens protector and twist it to the left (counter-clockwise) to remove it. Now remove the two bolts just above the fog light - the whole thing comes out as an assembly.
See "Front Fog Light" on page 52 in chapter 11 "Maintenance and Service" of your "OWNER'S MANUAL".....
Take them out then put the new ones in
On my 2001 Subaru Outback Wagon H6-3.0, it's on the driver side(L/H), in front of the wheel well, hidden behind the fog light...
Access from under the front corner of the car. Remove or push small plastic cover out of the way. Unplug bulb and rotate to remove.
how do you replace a bulb in a fog light on a 2000 maxima?
To install fog light in a 2000 Trans Am, disconnect the fog light switch from the housing. Then remove the washer, bolt, and nut. Finally, remove the fog light housing, twist the fog light off, and replace. ?æ?æ
There is one screw that holds the fog light it into place.Unscrew that screw and the fog light will pull out of the bumper.
Replace the bulb, had to change one myselfe.
Left hand side of dash, there is an area that has three rectangles. There are only cover plates on the rectangles with a low option Legacy. Otherwise it's Rear Defog, Cruise On/Off, Fog Lights.
You will have to access the fog light bulb from below the vehicle. Remove the plastic clips from the wheel well cover extension that is below the fog light. Once the clips are out and the plastic cover is pull down, you should be able to see the back of the fog light. You can try to replace the fog light bulb now or remove the two 10mm bolts and slide the fog light assemble out through the front of the bumper. Turn the cover of the rear of the fog light and replace light.
I have a 2000 Malibu and the fog light button is to the left of the steering wheel close to the cupholder.
replace it