You can customize your pool by adding accessories like a slide. It's not really possible to modify the pool itself and there are limits to how much you can change the appearance.
There are professional pool design companies that can custom design and manufature a pool for you. I would check out www.splashdesignsllc.com they are one of the best in the US.
Sounds like the jell coat on the pool needs redoing.
form_title= Fiberglass Pools form_header= Relax in the water with a fiberglass pool. Do you want a salt water pool?*= () Yes () No What size is your backyard?*= _ [50] What is your budget for a pool?*= _ [50]
No as long as the skimmer section of the pool is properly supported like the rest of the pool
I doubt it, Gunite is normally used in swimming pool structures and it could very well look like asphalt
the cost for fiberglass pools are chaeper and easier to install.concrete pools are easier to maintain.a fiberglass pool may run you 3,000 to 10,000. A concrete pool run you 12,000 to 30,000 depending on the size and area of residence
Yes, fiberglass pools have a smooth finish. Where a concrete pool was a pourus and rougher finish that gives alge something to grab on to. Also staining it. A low calcium level can pit a concrete pool, not a fiberglass, plus a fiberglass pool is more flexible,so ground movement wont crack it. In the long run the extra money you pay for fiberglass is worth it.
Absolutely, But if you only have the land to fit a fiberglass pool, Your new gunite pool will be considerably smaller by about 1 foot all the way around. A fiberglass drop in pool is too small already, RIGHT? Kenny Kummer Brody Chemical
Hum, not sure if you can actually plaster a fiberglass pool. The glass would have to be removed first. You will have to consult a pool builder, a company that installs fiberglass shells or a company that installs fiberglass in plastered pools - thus converting a gunite/plaster pool into a gunite/fiberglass pool. The later uses the old pool shell as the sub-grade or foundation so to speak. k
No!!! Under no circumstances should you drain a fiberglass in-ground pool. Unlike the standard in-ground pool, the fiberglass pool base is unreinforced concrete or other hard surface material that was applied directly to the soil in a thin layer. It is only there to allow the fiberglass to be sprayed on and form a hard shell. The weight of the water is what holds the fiberglass in place. If you drain the pool without refilling it immediately, you will allow external ground pressures and/or ground water to buckle the sides or bottom and you will have the fiberglass completely redone.
Fiberglass pool shells are shipped in a single piece directly from the manufacturer. As a result, you don't actually linea pool with fiberglass the way you would with concrete or vinyl. Instead, installing a fiberglass pool simply means digging a hole in which to place the already completed shell.
A fiberglass pool requires less maintenance, less repairs structurally in the future, is quick to install, and is good for smaller pools. Gunite pools are better for a pool deeper than 8 feet, custom shapes, and is a bit harder on the feet than a fiberglass pool.
You can place fibergrass around your pool to make your pool look more appealling without having to replace the entire pool. You can also make an entranceway with fibergrass to give a more antique look.