Want this question answered?
Answerif the oil was changed in a garage they could have bumped the abs sensor when they were greasing the lower ball jointsSee "Related Questions" below for more about the Windstar ABS systems
The ABS sensor is located in the front brake set up. It is accessible by removing the tire and the caliper bolt, caliper, and rotor. It will be a black plug connected to a wire sitting on the top.
It is important to know where the fuses and relays are in a vehicle. The ABS relay in a 99 Ford Windstar is located in a fuse box under the hood.
2005 Ford Escape ABS Sensor - from $26.49+ |
The 2000 Ford Windstar ABS relay switch is located on the firewall in the engine compartment. The relay switch will be on the passenger side of the engine compartment.
This could be referring to the ABS control module.See "Related Questions" below for more
how do you check the abs sensor on a 1998 contour
There is just a rear one I believe, on top of differential
Your Windstar is subject to a Ford recall for the cause of this problem.The cause is a leaking brake pressure sensor screwed into the bottom of the master cylinder.I would suggest contacting your Ford dealer confirm your van is covered (I believe every single Windstar is part of the recall), and arrange for the quick and easy repair.See "Related Questions" below for more
Anti lock ( antiskid ) braking system
replace abs sensor on back axel.
See "Related Questions" below regarding ABS wheel sensors - including how to replace them.