This person gave a very detailed description of how to remove the bumper.
http://www.rcaz.com/rcaz/sub%20indexes/eclipsebumper/index.htm
Remove the screws in the wheel wells and underneath the plastic cover to remove the bumper cover. Then you can see to remove the actual bumper.
Unbolt the front of the wheel well liner inside the wheel opening.Remove the bumper cover bolt from the bracket located inside of the bumper at the end.AT the front of the car, remove the bolts holding the bumper cover on, located underneath the vehicle.You should now be able to remove the bumper cover from the front of your Dodge Intrepid.An instructional video has been included to show you the removal process.
you need to take the whole front bumper off and it sucks! : I have a 99 GST and I have changed both of mine to aftermarket lamps it was an electrical connector, 4 bolts and I did have to pull the signal completely out but I did not need to remove the front bumper cover.
It should be behind the front bumper, in the front part of front left bumper.
Not Necessary but helps a lot: Jack the front of the car up on both sides and remove the front wheels. Remove the bolts that hold the plastic fender well up. If you look at the seam where the front bumper cover meets the right front corner panel (one's metal and one's plastic) there are more bolts to remove. Pop the hood, and remove the push locks that hold the plastic bumper to the metal frame in front of the engine on top of the radiator. The front bumper cover should fall off (if you don't want it scratched lay a towel down in front to lay the bumper on. From there, remove the two bolts that hold the front Chevy symbol to the bumper cover. and pop it off.
throw a hand grenade at it
Park the Impala on a level surface and engage the parking brake. Remove the keys from the vehicle's ignition.Crawl underneath the front of the vehicle and use a slotted screwdriver to pry off the splash shield in each wheel well directly in front of both front tires. Once the shields are removed, you can access the screws securing the bumper cover to the fender.Remove the two screws on each side of the bumper cover with a Phillips screwdriver.Remove the bumper cover from the front of the vehicle by pulling it up and off the Impala. You may need another person to help you remove the bumper cover. Install a new bumper cover by placing it onto the front of the Impala.Crawl underneath the Impala again and reinstall the two screws on each side of the bumper cover. Reattach the splash shields to the wheel wells.
First remove the bumper cover. You need to take off the front grill to get at the plastic retainers that hold the top of the buimber on. There are about four retainers on the bootom of the bumper.
This video on YouTube (see Related Links) will show you how to remove the front bumper cover from of a 2004-2007 Honda Accord.
It should be behind the front bumper, in the front part of front left bumper.
In order to remove the whole assembly, you have to remove the front bumper cover which will expose a bolt on the bottom of the assembly which has to be removed...along with the bolt on top of the radiator support beam on each headlight!
# Apply parking brake,raise the vehicle and secure it # working under the vehicle,detach the fasteners securing the lower edges of the bumper cover # Working in the front wheel opening,detach the retaining screws securring the bumper cover to the inner fenderwell splash shield # Pry out the lower edge of the splash shield,then reach up behind the bumper cover and remove the bumper cover fender retaining nuts # remove the fasteners securing the upper portion of the bumper cover and pull the bumper cover assembly out and away from the vehicle. # Disconnect any electrical connections which would interfere with removal