Want this question answered?
has the engine run since new timing belt put on? if not whoever did the work, didnt get the timing right.
To fix a Mitsubishi 2.0 timing belt, one will need a crank pulley. Simply pull the crank pulley and the top right engine mount to put the timing belt in its proper position.
99 zx2 has a non interference engine. This means if the timing is off or the timing belt breaks, no damage will occur to your engine. If you replaced the belt and your engine runs rough, misfires, bucks, that means you didn't put the timing belt on right. It's got to be put on perfectly with the crankshaft at TDC and the cams aligned. Have fun. If you can figure it out, you can take it to a Ford dealer to have the timing belt put on properly.
have take motor and trans out 1996 Honda accord put timing belt
That engine doesn't use a timing belt.
you need a large socket and a breaker bar to manually turn the cam until the timing mark is placed right
When you have the belt put back on correctly it will be back in time.
RF tire, lower belt shield, accessory belts, crank pulley, ps pump, AC lines, right engine mounts, right engine mount bracket, outer timing cover.
Remove valve cover, then remove the side time belt cover. Check timing belt tension. If there's too much slack, loosen timing belt tensioner, put pressure against side of tensioner with long screwdriver, then tighten the tensioner bolt.
No-there is one belt tensioner for the entire engine belt assembly. The timing belt is a serpentine belt and if it is stretched out, it will need to be replaced. There is no way to adjust the timing belt once it is put on the vehicle.
I really need to know how to tell if i have a loose crankshaft or crankshaft position sensor. Or could it be the timing belt . We just put in a new water pump but the timing belt was on TDC when we were done. PLEASE HELP !!!! Its running pretty crappy...
In this case your car will give black smoke and it wont have much power to it and you have to get the timing belt taken off and set it up to its right place then put the belt back on it. Rememer your engine will be bit loud voice wise and if the belt was not installed properly.