Jack up the car in the front. , imagine the wheel as a compass, and grab it on the East and West sides, push and pull on it.
If you feel like its loose, watch the outer tie rod end where it attaches to the knuckle or suspension - if you see it moving with any play on that joint, chances are you need an outer tie rod end.
If you don't see it moving there, chances are you need an inner tie rod.
See "Related Questions" below
The average cost to replace a tie rod is approximately $200. You can save about $125 of labor by replacing the tie rod your self.
Yes, replace tie rod and have the car realigned.
Remove the tie rod nut. Pop tie rod out of the hole in spindle. Unscrew tie rod from steering box. Install new tie rod in reverse order. Have front end aligned.
Remove the old tie-rod from the knuckle. Loosen (or preferably replace) adjusting sleeve. Put on new tie rod and tighten everything down. Then take it and get it aligned.
Inner tie rod end 185.00 with labor outer tie rod end 165.00 with labor plus alignment
The ball joint should be permanently in the tie rod end. If it is bad, you have to replace the entire tie rod end.
Is that inner or outer. If outer because these cars eat tie rod ends, you have to unbolt tie rod from hub, hammer out, make where tie rod is screwed ( for length ) use vise clamps and have to unscrew end. Try and be careful as to the exact location of the rod, might need some good loose nut, re-place tap in joint and tighten nut, might need an alignment after.
Take it to a garage as you need special tools and the alignment has to be set when you replace them.
The estimated cost to replace one inner tie rod end on a 2003 Isuzu Rodeo is between $121 and $227 including parts and labor. The estimated cost to replace one outer tie rod end is $118 to $205.
The tie rod is part of a vehicle's steering system and as such should not be replaced by a complete novice. If one is unsure, it may be best to get a garage to replace the tie rod. YouTube and wikiHow give detailed instructions on it's removal.
There are two types of tie rods on a 2000 Dodge neon. The outer-tie rod connect to the inner-tie rods which mount to the steering rack. The outer units are threaded on to the inner- tie rods. Remove them by spinning it counter clockwise. Take a special tie rod socket to remove the inner-tie rod. Replace the units.
how do you repair an inner tie rod for a 96 Pontiac sunfire no repair,replace with new.