0
How do I install an after market radio power into my 1999 alero?
Wiki User
∙ 16y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is wiring diagram schematic for radio on 1994 lhs with factory amplifier and install instructions for after market radio i get power but no sound?
get on internet: www.installdr.com for wiring diagram
Why when my 2003 Alero is sitting in the sun The car starts and runs but there are no accessories no dash lights no radio no power windows.. within minutes everything works fine?
I have same problem in 02 Alero.
How do you install an amp with the factory radio in a 2003 alero?
Your in luck my friend i have the same year of car all i used was a inline converter that's hooked up to the back 6x9 speakers
Is it best to install a factory radio or after-market radio in my vehicle?
Factory radios are made especially for certain vehicles and there fore mesh better with your cars system.
How do you install cobra cb radio in 2010 Chevy lumina?
To install a Cobra CB radio in a 2010 Chevy Lumina, first disconnect the battery cables. Then mount the CB box and then power the CB radio. Then mount the antennae.
Does the original radio in an alero 01 have rca jakes in the back?
no
Do you need a Amp if you replace your stock radio with an after market radio in a 2001 Olds Alero?
you only need an amp to boost the bass in your stereo system with a sub woofer (10'', 12'',15'') so No you don't necessarily need an amp!!
How do you replace the radiocd player in a 2003 Chevy cavalier 4 door sedan?
I need to replace the after market radio/cd player in a 2003 Chevy Cavalier. How do I get the existing radio out and install a new one. How do you remove the dash trim without damaging the retainer clips and all the other plastic parts, then install the new after market radio/cd player?
Why does the radio head unit just completely power off in the 03 Olds Alero when driving Is the Ipod Adapter installed incorrectly?
I have this same problem...any answer?
Wiring a radio in a car?
You will need a 12volt power source, speaker wire pairs leading to each speaker enclosure, speakers and a radio. You also need a location in which to install the radio.
How do you install a new stereo in a 98 Chevy Malibu?
Pull out the ashtray and pop out the panel covering your stock radio, a/c, & tape player. It just snaps out. Unscrew the 2 screws holding the factory radio in. Install your after-market radio and pop the cover panel back on. Seems almost to easy right?
If there is no power getting to your 94 VW Jetta radio how do you fix it?
Check the fuse in the fuse panel. Also look and see if there is an inline fuse blown. I already checked the fuse panel and the fuse on the back of the radio. I don't know what the problem could be. The radio is not burnt because I replaced it and still no power. There may be another inline fuse somewhere between the fuse panel and the radio. Do you have power at the radio? I assume you do not. I would check, with a multimeter, where the radio power cable is connected at the fuse panel and see if you actually have power. If you do then you know that somewhere between that point and the radio you have a problem. As a last resort you could just run a new power cable to the radio from the fuse panel. Be sure to install an inline fuse if you do this. How do I run a new power cable to the radio from the fuse panel and install an in-line fuse?
