I would like to know how you put four wheel drive into a luxury car........
rear wheel drive
Five On five lug!
attached to the frame on the drivers side in front of the rear wheel
The 91-96 Buick Roadmaster as well as the rest of the b-body (Impala ss Caprice Fleetwood) line have 5x5 bolt pattern same as 90's models 2 wheel drive tahoes and silverado pick ups
do I remove steering wheel to change out ignition
Remove the wheel(s), remove break caliper (set aside on a block of wood so that the break line doesn't take any stress) then simply pull off the rotor and replace with new rotor. Installation is the reverse of removal.
if you have lost the locking wheel nut key to remove the locking wheel nut then you can still remove the nut by getting a socket that is a tight fit on the nut and hammering it onto the locking wheel nut then it will undo. i worked in a garage for a few years and everytime a car came in with your problem that's how we solved it.AdditionMost breakdown patrols and breakdown garages carry special tools for the removal of locking wheel nuts
Understand you have to go in through the wheel well on the passenger side of the vehicle. This is quite a labour intensive procedure.
remove wheel. remove brake caliper. remove center "dustcap" from rotor. remove cotter pin. remove nut lock. remove adjuster nut. remove rotor. the rotor has the studs pressed into it so you now have 2 options. 1: press in new stud(s) 2: replace entire rotor.
apply handbrake, find the locking wheel nut, remove toolkit from boot, crank the wheel nuts on said wheel (do not remove), affix jack, pump the jack till the said wheel has airtime and remove the loosened wheel nuts. and as ramsey would say 'done'
remove the steering wheel and use eff-7
No, you do not have to remove the wheel/tire.