0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How does a coil work in a MGB?
how does a coil work in a MGB
How can you fix a heater and AC fan that only work on high?
Resistors control the speed of the AC/Heater fan. These resistors are switched on and off in various combinations to create the different fan speeds. When the resistors burn out your fan will only work on the "HI" setting. The "HI" setting doesn't use any of the resistors and that's why it works. These resistors are near the blower and the blower is beneath the dashboard on the pasenger side. Just have to located resistors now.
Why does the fan work only on high and keep blowing resistors on low?
Had one that the fan motor was going bad Was burning out resistors with high draw
What is a Heat Anticipator?
A Heat Anticipator is really a potentiometer connected to (possibly) two resistors. You may see these resistors behind a mechanical thermostat "coil". When the heater is running, current flows and heats up the resistors, making the heater turn off a little early so that it doesn't overshoot the temp you have set. If the pot is set at it maximum resistance, the resistors heat less, it just makes sense. Check your manual on your thermostat for proper settings.
What would happen to the power dissipated in the voltage divider?
'Power dissipation' in a voltage divider describes the rate at which energy is transferred from the resistors to the surrounding atmosphere through heat transfer, due to the work done on the resistors by the current flowing through them. If the work done on the resistors causes their temperature to increase faster than heat transfer takes place (a function of the surface area of the resistors), then they will overheat and, possibly, burn out.
Self inductance of a given coil by Andersons method?
Anderson's Bridge is an AC bridge. It is used to measure self inductance of a coil using a capacitor and resistors. The bridge continuously balances itself by a steady current through a moving coil galvanometer replacing a headphone and a battery replacing an A.C. source. The resistance is adjusted until the currents two specific resistors in the center of the arrange are the same. Then inductive balance is achieved by using the A.C. source and headphone in their respective positions.
What are those materials of resistors?
most of the resistors commonly used are carbon resistors
When using an arduino controlling a relay- why are resistors used with the transistor to activate the relay coil?
Because without the resistor, there would be a short from the base to ground, and sometihng would smoke.
Your driver's information doesn't work on your dashboard for your 2000 buick regal?
It sounds like the resistors have broken loose and fallen off the back or the instrument cluster. Remove the cluster and open the back. flick the resistors some may fall off.. replace missing resistors.
Why would the heating-AC fan on a 1994 Dodge Caravan only run on high?
Resistors control the speed of the AC/Heater fan. These resistors are switched on and off in various combinations to create the different fan speeds. When the resistors burn out your fan will only work on the "HI" setting. The "HI" setting doesn't use any of the resistors and that's why it works. These resistors are near the blower and the blower is beneath the dashboard on the pasenger side
What is carbon composition resistors?
Carbon composition resistors are resistors that are made with carbon or graphite mixed with a binding material. It's one type of resistors among several. There are also carbon-film resistors and metal-film resistors. Out of all the resistors, carbon-film resistors have the greatest tolerances and changes to temperature fluctations. Thus, they are used in applications where precision isn't critical and where temperature will not change drastically.
How do you find the resistance of a series circuit with n identical resistors?
The total resistance of resistors in series is simply the sum of the resistance values of those resistors. If the resistors are identical, then you can multiply the resistance of one of them by the number of resistors in the circuit.
