The way I usually see this done is to go through the firewall and under the carpet along the door sills, under the back seat and into the trunk.
take the negative batter cable off, then the positive cable off, undo batter hold down clamp, take battery out. put new battery in, install batter hold down, install positive cable, then install negative cable. (in that order)
1. Remove negative battery cable 2. remove positive battery cable 3. remove battery 4. install new battery 5.attach positive cable 6.attach negative cable
Remove the old battery, disconnect the negative cable first and install the new battery connect the negative cable last.
Open the hood, disconnect the negative battery cable FIRST, then the positive cable, then remove the battery hold down clamp, then lift the battery out. Install in reverse order.
Remove cables from battery Remove + cable from the starter solenoid Remove the - battery cable from engine ground install new cables using the same routings as original
About 30 min.
Yes This Cable Is Connected To A Group Of Cables That Run To The Battery Positive Side, To Allow The Alternator To Charge The Battery.,Do Not Remove Or Install An Alternator Until You Remove The Ground Terminal From Your Battery.
Remove the positive battery cable from your 1997 Toyota Corolla battery. Tighten the starter with the retaining bolts. Attach the cables to the front of the starter. Reattach the positive cable to the battery.
try disconnecting positive battery cable from battery for a few minutes,then,re-install
Install the positive cable to both batteries. Install one cable end to the battery and the other end to the engine bracket of the other car. Remove the cables in the reverse order.
Sure you can. Just remove the old battery and install the new one identically as the old one was connected. Disconnect and reconnect the negative cable first.
Disconnect the negative cable from the battery. Now disconnect the other end from its ground point. Take that cable to you local auto parts store and buy a replacement. Reverse the procedure to install it.