0
How do the injectors receive a pulse signal on an 88 jeep 4.0 in line 6-cylinder engine?
Wiki User
∙ 17y ago
from PCM (powertrain control module)
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
No pulse to injectors on a Nissan Sentra?
Make sure you have the ignition supply for the injectors. Check the starter signal input to the engine computer.
1992 cavalier injectors not getting signal and no fire to plugs?
Check the camshaft sensor. If the sensor is bad or not getting power, then the engine will not fire and the injector will not get a signal.
What could cause your 1991 caddy deville's engine to race sometimes on startup?
the deville is famouse for computer problems, once the car is started the brain sends a signal to the injectors to puch out an introductory supply of fuel for startup, basically this signals tells the injectors how long to stay open, perhaps the signal is telling the injectors to stay open too long or too much, good luck.
Where does wireless transmit and receive signal from?
It has an access point which transmit signal to the client and receive.
What could cause no gas to flow through the fuel injectors when cranking the engine?
hi: sometime it is the fuel pump or fuel filter clogged. i would listen for a noise ,after you turn ignition on but not start car. if you hear fuel pump come on most time it is fuel filter clogged and or not enough pressure on fuel pump and or bad or dirty injectors. hope this helps a little Ron Depending on the vehicle, there's crank signal coming from the distributor, this allows the fuel system to operate. If the ECM doesn't receive the signal from the distributor, then it won't allow fuel to the engine. Some time a car with distribuless ignition it has a bad crank sensor.
All fuel injectors stuck open on your 1991 Nissan 300zx?
When all fuel injectors are stuck open, this generally means that the injectors are not getting the right voltage. You will need to not only check the voltage, but make sure the injectors are receiving the right signal.
What is a VW Jetta engine speed sensor?
The engine speed sensor provides the ECM with a crankshaft position signal. The ECM uses the signal to determine a crankshaft reference point (Top Dead Center) and calculate engine speed (RPM.) The signal is also used by the On-Board Diagnostic system for misfire detection. The ignition system will not operate if the ECM does not receive an engine speed sensor input.
What is the name given to the brain of the Mercedes SL that gives the correct signal to the engine to run?
RPM Relay The pulse from this relay, tells the computer to send electricity to the fuel pump to provide fuel to the injectors to start the engine. The pulse is detected from the ignition system while the engine is cranking.
94 Taurus 3l no signal to fire injectors?
A malfunctioning fuel injector pump will cause the injectors to not fire properly. The fuel injector pump will need to be replaced.
How do you fix a constant ground signal from your EC to your fuel injectors?
Sounds like the ECM is toasted.
How do you tell if the fuel injectors are bad?
Use a temperature checking device on the exhaust ports or pipes after you have ran the engine (about 5 minute's) to identify the cylinder in question, It will be cooler. If the injector is electrically activated use a noid light or volt meter to check the signal at the connector to the injector. It is a pulsed signal.
What should you do in a 1995 Chevy G20 van if you cant get the injectors to fire when they have power to them unless you hot wire them?
No pulse signal to injectors (bad injector relay or PCM driver circuit).
