answersLogoWhite

0


Best Answer
buy a manualeveryone hates to spend an extra 15-20 bucks but you need to go and buy a Haynes or Chilton manual specific to your vehicle at Autozone or another type of auto parts store. these books are life savers to say the least. I could give you a basic break down of how to do it but i don't drive a full size Chevy and i might miss an important step. go buy the manual and follow it exactly and you will have the job done in less than an hour.
User Avatar

Wiki User

โˆ™ 2011-09-13 00:13:25
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you Change front wheel bearings on a 2002 Chevy silverado 1500 2 wheel drive pickup?
Write your answer...
Submit
Related questions

How do you change rear brake pads on a 2003 Chevy silverado 4 wheel drive pickup truck?

How do you change brakes on 2003 Silverado Pick Up?


How do you change front wheel bearings on a 2003 Chevy silverado 4 wheel drive pickup truck?

you can't replace just the front wheel bearings, they are sealed so you have to replace the entire hub assemble and it will cost approximately $130 each side.


How do you change the wheel bearings on a 2005 Chevy 4 wheel drive pickup?

If you are referring to the front bearings, you have to buy a complete hub assembly.


Cost of insurance for Chevy Silverado pickup?

The cost of insurance for a Chevy Silverado pickup is not a set price. The cost is determined by the driver, the company, and the coverage needed.


Where is my hood latch located on a 1999 Chevy Silverado?

where is my hood latch located on my 1999 Chevy silverado pickup


Can you change the power window switch in a 1986 Chevy silverado pickup without removing the door panel?

No you can't.


What happens when back bearings go out in a 2002 Chevy silverado?

You replace them ! :)


Where is the ignition coil on a 1986 Chevy silverado pickup truck?

no


When was the first line of Chevy Silverado trucks produced?

The first Silverado Chevy was released in 1998 and it was a light pickup truck model named GMT800 Silverado. Prior to this, the term "Silverado" was used by General Motors to refer to the trim for the Chevrolet C/K pickup trucks.


Where is the shift solenoid on a 98 Chevy silverado pickup?

The 1998 Chevy Silverado pickup truck shift solenoid can be found on the left-hand side of the engine. The shift solenoid will be near the center of the transmission.


Do the headlights automatically come on for a 1999 Chevy Silverado Pickup?

Yes.


How do you change a distributor on a 98 Chevy Silverado?

how to repace the distributor on an 98 chevy silverado


How do you change the air conditioner belt on a 2004 Chevy Silverado?

how do you change the air condition controller in a 2004 chevy silverado


How do you change the knock sensor in a 2003 Chevy Silverado 5.3?

how do you change the knock sensor in a 2003 Chevy silverado 5.3


Do you need to pack the rear bearings on a 2000 Chevy silverado 1500?

NO Rear bearings are lubricated with the rear end / gear oil.


Can you install an external oil pump on a 1994 Chevy silverado?

NO YOU CAN NOT. It will not lube the engine bearings.


What size motor is in a 1996 Chevy Silverado 1500 Pickup?

The Chevy SBC 5.7L 350cid V8 was the standard


How do you change the cabin air filter in a 1989 Chevy silverado?

There is no cabin filter on a 1989 Chevy Silverado.


Where is the oil filter in a 1995 Chevy Silverado?

under the pickup in the center of the engine block


How do you hot wire 1990 Chevy Silverado pickup?

im stuck and I need help


How do you change pickup coil on 1978 Chevy pickup?

u have to pull the whole distributer to change the pickup coil


Where can iyou find a a equals diagram for the tailights on a 1977 Chevy pickup?

which fuse goes to the tailights on a 1977 Chevy silverado


How do you change the ignition control module in a 1988 Chevy Silverado 5.7 L?

How do you change the ignition control module in a 1988 Chevy Silverado 5.7L


Can you repack the front hub bearings on a 1998 Z71 Chevy pickup 4x4?

The hub bearings in a 1998 Z71 can not be repacked. The bearings are part of the hub, and the hub assembly will have to be replaced.


Instructions on how to change the rear hub wheel bearings on a 1996 Chevy cavalier?

Instructions on how to change the rear hub wheel bearings on a 1996 Chevy cavalier