answersLogoWhite

0


Best Answer

you'll need a replacement sensor with either an exact fit or universal connector. The front sensor is visible sticking out of the exhaust pipe, if you open the hood and look near the bottom of the engine underneath the air intake tube (big plastic piece connected to air filter housing that bolts in above radiator). Rent a o2 sensor socket for free from an auto shop. You'll probably need to remove the air intake tube to access the o2 sensor, easy to do by unbolting and pulling off from air filter housing. Disconnect old sensor from electrical plug, and remove with the o2 sensr socket. replace with the new sensor and replace the air intake tube... whole thing takes 30 minutes at most.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you Change o2 sensor on 93 probe gt?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Will the Ford Probe GT raise your car insurance?

No it won't. I had a 95 Ford Probe Se 2.0L and when the transmission went i upgraded to a 93 Probe Gt 2.5L V6 and my insurance didn't change at all. I love the car.


Where is the 93 ford probe gt knock sensor?

On the Ford Probe 93-97 GT's the knock sensor is located underneath the intake manifold. More specifically it is threaded into a fitting on the deck of the engine block in between the heads in the Valley. Shouldn't be too bad if your an experienced mechanic or a mechanically inclined individual. Hope this helps ya out, and good luck.


Where is the coil on a 1993 Ford Probe gt?

On the '93-'97 GT's the ignition coil is part of the distributor. If your coil goes bad you need to change the distributor.


What are a few factors to why my 93 Ford Probe gt will not idle?

MAF(Mass Air Flow) sensor, TPS(Throttle position sensor) sensor, IAF(Intake air flow) sensor, EGR, leaking, loose or missing vacum hoses...


Would rims that fit 5x115 fit your ford probe gt?

Yes, year model 93 thru 97 Ford Probe


Where is your cam sensor on your Ford Probe gt?

the camshaft sensor is located in the distributor. you need to purchase the entire distibutor to replace the sensor.


When ford probe 95 engine 2.5 GT is hot -is not working?

Temperature coolant sensor...


1996 Probe GT code reader says o2 Sensor Bank 2 Sensor 1 is out is this front or rear sensor?

(front) sensor 2 is after the cat


How do you change oil pressure switch on ford probe gt?

o my


Where is the temp sensor plug into on a 93 mustang gt?

the temp sensor is on the top, front of the engine by the water neck


How do you remove the driver's side cv joint on a 93 Probe GT with ABS?

pull real real hard it will come


93 probe gt replaced mass airflow sensor car turning over not starting replaced distributor and wires - any suggestions plan to pull codes this evening?

Check condition of ignition coil. Replace if bad.