0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you reset maintenance light on Toyota Corolla 2010?
How do you reset maint read light on 2010 corolla
How do you reset the maintenance required light on a 2010 Scion XD?
You will find that info in the owners manual.
How to reset maintenance service indicator on 2010 glk 350?
Resetting the maintenance service indicator on G.L.K 2010
How do you reset the maintenance other light on your 2010 Nissan Maxima?
pressing the red button, everyone says not to but in this case u should.
How do you reset the maintenance light after an oil change on a 2010 Chrysler Sebring?
The oil change light is reset by Key on, engine off. Press the gas pedal to the floor three times. Cycle key off and on.
How do you reset oil maintenance on 2010 Lexus gx 460?
How to reset oil maintanance on a lexus gx 460
How do you reset service indicator for 2010 ML550?
reset service light on 2010 ml 550
How do you reset timing belt light model 2010 toyota coaster bus?
coaster bus how do you reset timing belt light 2010
how to reset holden commodore engine light 2010?
Reset the device by debugging it.
How do you reset service light on 2010 Honda Accord?
Turn the ignition switch to the ON (II) position.Press the select/reset knob repeatedly until the engine oil life indicator is displayed.Press the select/reset knob for about 10 seconds. The engine oil life and the maintenance item code(s) will blink.Press the select/reset knob for another 5 seconds. The maintenance item code(s) will disappear, and the engine oil life will reset to "100."NOTE: After the engine oil life and maintenance item codes start to flash (blink) you must RELEASE the reset knob and press again for another 5 seconds. It will then reset.
How do you reset the abs light on a 2010 Jeep Grand Cherokee?
The abs light is reset with a scan tool after repairing the failure that caused the code.
How do reset air bag light on a 2010 jeep wrangler?
The airbag light stays on when the computer has detected a malfunction and set a code. The light can not be reset until the failure is repaired.
