Peugeot
Wolves
Climatology and Climate Changes
Peugeot 106

How do you adapt pug 106 headlamps for continental drivinge Eurolite masks dont have instructions for fitment to a 106?

464748

Top Answer
User Avatar
Wiki User
2006-04-11 12:37:56
2006-04-11 12:37:56

The cheap and easy way to do this is nose the vehicle up to garage door and turn lights on. You will notice a flat horizontal beam of light from each light, then at one side (left side) you will notice the beam of light goes up at about 45 degrees to the horizontal beam. This is called the kick up and is the bit you need to get rid of to drive abroad as it dazzles drivers. All i do is get some black tape and stick it on the light lens until the kick up disappears. Use as little tape as you can to do this as you dont want to block the whole headlight out. Might be a good idea to get a piece of card board rectancle about 3" by 1" and slide it over the light until you find the best place to stick the tape. Hope this helps

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Go to the library and look up the automobile and you will find the instructions in the book or ask for instructions on computer

User Avatar

If you are referring to xenon headlamps, none of the S-series Saturns had Xenon headlamps. They are halogen headlamps (I used to sell Saturns).

User Avatar

pull of the velcro cover, then locate the little metal tabs behind the headlights. Pull thses out, and the headlight cases will pop right out

User Avatar

There is a plastic cover in the front wheelwell that gives access to the headlamps

User Avatar

dusk sensing headlamps are headlights that turn on when it starts to get dark/dusk. They automaticly turn on!

User Avatar

FMVSS 108 says the maximum candlepower of headlamps is 200,000

User Avatar

Try looking through the small Owners Manual - I found great instructions on replacing the headlamps there. Also, which indicator bulbs are you asking about: front and/or rear??

User Avatar

Headlamps originally designed, built, tested, and certified as HID headlamps are legal in all 50 states. So-called "HID kits" to convert halogen headlamps are widely available, but they are (all) illegal and dangerous; halogen headlamps must use halogen bulbs.

User Avatar

Headlamps originally designed, built, tested, and certified as HID headlamps are legal in all 50 states. So-called "HID kits" to convert halogen headlamps are widely available, but they are (all) illegal and dangerous; halogen headlamps must use halogen bulbs.

User Avatar

Headlamps originally designed, built, tested, and certified as HID headlamps are legal in all 50 states. So-called "HID kits" to convert halogen headlamps are widely available, but they are (all) illegal and dangerous; halogen headlamps must use halogen bulbs.

User Avatar

Yes they can as long as they are the standard headlamps, the LSC you would have to get the ballast etc.

User Avatar

To get the correct aim of the headlamps in a 2008 Toyota, simply have a look at the user manual.

User Avatar

Headlamps originally designed, built, tested, and certified as HID headlamps are legal in all 50 states. So-called "HID kits" to convert halogen headlamps are widely available, but they are (all) illegal and dangerous; halogen headlamps must use halogen bulbs.

User Avatar

Basicly they Are headlamps that stay on for 60 seconds after the car has been locked.Basicly to show you home in the dark

User Avatar

Have you tried pulling the round headlamps switch/knob out (ie. toward you), when the headlamps are switched on ?

User Avatar

less than 2 headlamps on a ford a model 2 headlamps take 12A

User Avatar

the first will be check for a blown fuse at headlamps fuse box

User Avatar

Not sure what you are talking about? Program what about the headlamps? You can ask this question on Smokinvette.com and maybe there is something that I am missing about your question! Good luck!

User Avatar

HID headlamps designed, engineered, manufactured, and certified or type-approved as HID headlamps are legal everywhere. "HID kits" and "projector retrofits", where HID bulbs are installed in headlamps not originally designed to accept them, are unsafe and illegal everywhere.

User Avatar

Start by reading the manual that came with the car. Check the section on "How to replace headlamps." Might be a good start.

User Avatar

It could be that the headlamps are burned out or it could also be that the high beam switch has failed.

User Avatar

I think there is a plastic shroud covering the top of those headlamps. If you unscrew the plastic piece above the lamps you should see the adjusment screws The headlamps will only adjust vertical. When you open the hood and look down at the headlamp you will see one small bolt at the bottom corner of the lamp. Turn this to adjust the headlamps vertically. There is NO plastic piece to remove.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.